0
What else can I help you with?
What size bolts should I use to mount my TV?
To mount your TV, use M8 size bolts.
What size bolts should I use for a TV mount installation?
For a TV mount installation, it is recommended to use M8 size bolts.
What size lag bolts should I use for a TV mount installation?
For a TV mount installation, it is recommended to use lag bolts that are at least 2.5 inches in length and have a diameter of 1/4 inch. These bolts should be able to securely hold the weight of the TV and mount on the wall.
What size are the engine mount bolts on a John Deere LT155?
I read online on some forum that they are 8mmx25mm bolts and JD part number is 19m7867.
What size are the motor mount bolts on a 99 vw jetta?
3/8 by 3inch grade 8
Saturn sl1 where's the upper motor mount located How do you replace it?
The upper engine mount is on the passenger side of the vehicle right in the middle of the engine. There are 5 bolts holding it on. The bolts are a size 15mm deep socket. Remove the two bolts on either side. Jack up the engine from the bottom, underneath the oil pan, using a piece of wood between the jack and pan. Now remove the 3 bolts holding the mount to the engine. Replace the mount. Screw 3 bolts back in. Lower the engine and screw the two side bolts back in.
How many bolts on 99 silverados starter?
The starter on a 1999 Chevrolet Silverado typically has two bolts securing it to the engine. These bolts are usually 15mm in size. Always check the specific engine configuration, as variations may exist, but the standard setup generally involves these two bolts.
What size bolts do I need to mount the stand on a Samsung 8 series 2009 plasma tv?
To mount a Samsung 8 Series 2009 plasma TV, you'll typically need M8 bolts. The length of the bolts can vary depending on the specific wall mount you are using, but they are generally around 30mm to 40mm long. Always check the wall mount's installation manual for the exact specifications to ensure a secure fit.
What size tapcon should be used for securing a 2x4 to a concrete surface?
For securing a 2x4 to a concrete surface, a 3/16-inch diameter tapcon screw should be used.
What size bolts are used in a 1972 dodge dart transmission mount-slant 6 auto?
Bell housing to engine block, 4 bolts are 3/8"-16 and 2 bolts are 7/16"-14.
What bolt size to mount transmission to a Ls motor?
If you don't have the original bolts to see what size they are then you will have to just look at the bolt holes and see the size. Use a bolt and try screwing it into the hole.It should fit snuggly and no play side to side.Length will have to be trial and error.They should go all the way into the hole with at least 8 full turns.And they must clamp up tight. Use only grade 8 bolts.
What size and type of wall mount screws are recommended for securing a TV to the wall?
The recommended size and type of screws for securing a TV to the wall are typically M8 screws that are at least 2.5 inches long. Make sure to use wall anchors if needed for extra support.
