A Lada One. They are switchable between most Lada Models such as the 2101-2104-2105-2106-2107-2121. If you wish to purchase a new starter you can order one from Alan at Lada UK http://www.lada.co.uk
Yes, a starter motor from a 1.6 will fit a 1.8 and vice versa.
Yes, a starter motor can be placed in a Vectra CDTI 55.
i dont know how to fit a stater moter!!
Yes.
to fit a starter motor it is normally held in by 3 maybe 4 bolts dependant on what car it is. these bolts are normally easily found when the starter motor is found which will be located either on the back or the front of the engine. attached to the gearbox. there is aso the main feed wire connected to the starter which must also be removed but always remember to disconnect the battery terminals before removing the starter.
yes without a problem
Remove the center switch console. remove the 4 spring clips holding the square heater motor housing and remove the housing. Inside the heater motor housing Remove the two spring clips holding the heater motor in Remove wiring connections and then remove the heater motor. Install new heater motor and installation is in the reverse order of above.
Niva - magazine - was created in 1870.
Nasha Niva was created in 1906.
Nasha Niva ended in 1915.
Niva - magazine - ended in 1918.
Lada Niva was created in 1977.