answersLogoWhite

0

185-220 deg F

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What controls the radiator fans on a 99 Dodge Intrepid?

A temp sensor


What should the temp gauge read on a V6 2000 dodge Dakota 4X4?

Aroun the middle of the gauge, 195-210


Why does a 99 Dodge Intrepid heat up when the ac is turned on?

If your car is anything like my 2001 intrepid, it is because only one of your radiator fans are coming on when the temp sensor tells your fans to turn on. You hear a fan kick on, but it is only one of them. There are two.


Where is the engine temp sensor located on 318 Dodge pickup 2000?

Just to the side of the thermostat housing.


What is the running temp of a dodge Dakota?

factory thermostat should be a 180 degree stat.


What temp should your 96 dodge ram 318 run at?

Around 190-210


What should Coolant Temp be on 6.1 Dodge Magnum?

180-220 deg F


Where is heater control valve located on a 2000 dodge neon?

A dodge neon does not have a heater valve. The inside temp is adjusted with an airflow control door inside the dash.


2000 dodge neon Speed o and temp gauge dont work?

i have sort of the same problem on my dodge 2000 the temperature gauge recently went out and i replaced the sensor but the gauge always reads 0 your not alone with this one...


Does a 2002 dodge intrepid 2.7 motor fit into a 1999 Dodge Intrepid?

Yes, it will, but you would have to take the following parts off of your 1999 engine and install them on your 2002 engine first: Flywheel, left cam sprocket, intake, engine harness, plenum, valve covers, exhaust manifolds, alternator, temp sensor, and EGR valve/piping. Check out dodgeintrepid.net for tons of info on these cars.


What can be the cause of a 96 Dodge Intrepid to run hot?

No/low coolant, bad thermostat, dirty/plugged radiator (inside and/or outside of it), air pocket in coolant, electric fan relay, temp switch for fans, bad fans.


How do you replace a radiator fan on a 1999 Dodge Intrepid?

there are two fans take the clips off of the sides clips not bolts unhook the wiring harnest and lift it out and replace but if you are having overheating probs then you should check your oil if it ain't black you might have a prob you can also cheak your relay in the fuse box the termostate or the temp sensor