The Injector nozzle consists of a needle valve and a series of fine orifices in the nozzle tip. Its task is to inject fuel in an atomised spray pattern and distribute it into the combustion space.
by rotating the ring which cover the opening of the nozzle
Find out who makes the engine and ask them
The Fuel injector nozzle
in appropriate injector's, clocked injector nozzle's, injector pump diaphram ,(due to dirt fuel)
An atomizer is any kind of nozzle that will turn any fluid into a fine mist, You'd find them on spray-on deodorants, spray paints, hairsprays etc. A fuel injector is a nozzle that turns fuels into a fine mist for combustion.
jhdjhfjsadhf fhkjdshfkj dsflkhdskjf[dsfd
The pressure nozzle tip for the 4BC2 is a stainless steel injector tip that is found on some Subaru vehicles. The tip can be replaced with models that are made from brass or steel.
To shoot the rocket up into the sky.
Click the link and read the History of fuel injection which has been around since 1920.
It sends hot gases from the combustion chamber to the 1st stage turbine blades at the correct angle and speed
Pressure washers use an attachment called a chemical injector to siphon soap into the water stream. The chemical injector works based on the the physics principle known as the Venturi Effect. The Venturi Effect occurs when there is a restriction in a medium through which water or air is flowing. This restriction causes an increase of speed in the flow, but a drop in pressure. A chemical injector uses this drop in pressure to siphon chemicals or soap into the water stream. With a chemical injector, this drop in pressure is achieved by using a nozzle with a large opening. There are two main types of chemical injectors:Downstream injector- This type of chemical injector is placed on the outlet side of the pump. A special nozzle is used (as mentioned above) to decrease the pressure to that the chemical can be siphoned.Upstream injector- This type of chemical injector is placed on the inlet side of the pump to inject the chemical into the water before it enters the pump. This type of injector is also known as a "high pressure" injector because the chemical is pumped through the pressure washer, and is thus released at the high pressures with the water. This is the only type of chemical injector that you can use different nozzles with. Since the chemical is injected using the low pressure inlet hose (garden hose), you do not need a special nozzle to decrease the pressure on the outlet side. This type of chemical injector is usually not recommended, however, due to the fact that the chemical is circulated through the pump. This can cause seals, such as the pump's o-rings, to wear out faster.
I don't know..that's why I searched it up in the first place. :/ awkwardd