0
What three commands will change the current configuration mode of a router?
Wiki User
∙ 9y ago
1) #Configure terminal for configuration mode 2) #exit for previous mode 3) #ctrl+z for set up mode
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Which three commands will change the current configuration mode of a router?
router ripline vty 0 4interface fastethernet 0/1
What can be concluded from the output of the running configuration of a router?
The commands that are displayed determine the current operation of the router.
Which commands will change the current configuration mode of router?
#Configure terminal for configuration mode #exit for previous mode #ctrl+z for set up mode
Which commands will change the current configuration mode of a router?
#Configure terminal for configuration mode #exit for previous mode #ctrl+z for set up mode
What commands will change the current configuration mode of a router?
1) #Configure terminal for configuration mode 2) #exit for previous mode 3) #ctrl+z for set up mode
What are some commands that can be used to verify router interface configuration?
plague
On a router which actions can be performed in user mode?
view current router configuration
In a Cisco router when do changes made to the running-configuration take effect?
as the commands are entered
Which mode enables you to view and change the configuration of a Cisco router?
Global Configuration Mode.
If a router is booting with its default configuration register setting and its NV RAM lacks boot system commands from where will the router try to load the IOS image first?
Flash memory
Starting at the enable mode prompt what commands would you type to configure IP address 192.168.1.1 on interface E0?
I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#I will show the commands, together with the prompt, assuming the router name has not been changed. A subnet mask is also required; I will provide one. ^Z is Control-Z, used to exit configuration mode quickly: Router>enable Router#configure terminal Router(config)#interface E0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#^Z Router#
What is the purpose of NV RAM on a Cisco router?
That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.That's where the router's startup-config (startup configuration) is stored.
