There is usually a main water valve that comes into the house, locate this valve and turn it down. Installing a pressure reducing valve after water main valve will allow for adjustment of water pressure to proper setting.
no
The water pressure in my house is about 140PSI. Which is definitely dangerous. It happens more often than you would think. What happens is a city will use water supply lines which are too small for the water requirements. Therefore, they have to increase the pressure. You wouldn't want a pressure relief valve, because then if the pressure was too high, it would just spray water everywhere to release the pressure. You would want a pressure regulator installed, which is what I am working on for my house right now. Just to let you know though, you may have to get a thermal expansion tank for your water heater if you don't have one. See, the new pressure regulators have a check valve in them, which prevents water from traveling back into the city pipes once it has gotten into your house. When your water heater heats the water, the air bubbles in it expand, which increases the water pressure, and will probably cause your pressure relief valve on your water heater to blow. You can get a cheap water pressure meter at any improvement store to check it out. 50-60 PSI is ok. I would say you could take it up to 70 or 80 PSI safely.
Yes, definitely too high. It should ideally be 50-80 psi.
There are various kinds of pressure valves. Perhaps the 2 most common in homes are the PRV (pressure regulating valve) which is on most incoming water pipes from a city supply. This valve limits the pressure entering the home system, bringing it down from city mains pressure. The second is on every hot water tank, and this is a relief valve, which will open up if the pressure in the tank becomes too high and vent the excess water down the drain.
safety control
Install a pressure reducing valve
no
No!
you wash it with high pressure water. However watch out, do not use too high of a pressure.
You should not really have over 80 pounds of pressure. But a lot of people do. NO -- even with high pressure it should work ok
its sad
The water pressure in my house is about 140PSI. Which is definitely dangerous. It happens more often than you would think. What happens is a city will use water supply lines which are too small for the water requirements. Therefore, they have to increase the pressure. You wouldn't want a pressure relief valve, because then if the pressure was too high, it would just spray water everywhere to release the pressure. You would want a pressure regulator installed, which is what I am working on for my house right now. Just to let you know though, you may have to get a thermal expansion tank for your water heater if you don't have one. See, the new pressure regulators have a check valve in them, which prevents water from traveling back into the city pipes once it has gotten into your house. When your water heater heats the water, the air bubbles in it expand, which increases the water pressure, and will probably cause your pressure relief valve on your water heater to blow. You can get a cheap water pressure meter at any improvement store to check it out. 50-60 PSI is ok. I would say you could take it up to 70 or 80 PSI safely.
Yes, definitely too high. It should ideally be 50-80 psi.
It can get as high as you like but keep in mind that as the pressure rises the amount of water being pumped reduces and the strain on the motor increases.
It will erupt at 101 iso
Because water has moved out of the vacuoles, the pressure is not enough to hold the plant's leaves erect.
yes 181 is way too high for bld pressure