What you do is go back to the store you got your lock and ask a staff there to help you. And then ask him/her what your problem is so they can help you. Hope this works, bye.
Dial the correct number to open the lock. There is a combination dial on the machine.
You can't. (point blank)
There is no legal way to hack into a Master Lock Speed Dial. If having issues with getting into one's own speed dial then calling technical or some other form of support may be the best course of action to take depending on the scenario.
There are 9999 possible combinations for the lock once you forget the combination. However, it is possible to get it open by fully locking it and then slowly spinning each wheel until it gives. Not everyone is good at this, but some people can do it quickly.
Right.
The first combination lock was with a dial type system dated back to midevil times. But not nea similar to modern day combination locks.
Problems resetting and lock 3-dial combo lock
Take the inside plate off of the door, turn the dial until you see when the lock lines up. Probable a 3 or 4 nunber combination and left right or right left. you will be alble to tell once you look at the lock.
By definition, a combination lock cannot be picked, as it has no key. It can be "cracked" in some cases where putting pressure on the lock and diagnosing the dial can reveal the combination. It can also be "bypassed" where tools are used to open the lock without the use of the combination. Neither of these are "picking" the lock however. In order to pick a lock, it must have a key of some type.
If you know the combination, dial it in, then close the lock, then press and hold the "reset" button. Whatever number you set before releasing the "reset" button will be the new combination.
a simple pad lock or a combination lock. and if you forget the combo or lose the key you can cut off a small piece of the fabric
I'm not sure which master lock you are asking about, but see related links below for methods of opening combination locks