You don't. The security system is built into a couple of the computerized modules including the PCM. Basically the comuter needs to see the chip in the key or it will not start.
Please note that you can bypass the security system by installing an equivalent resister across the two wires that go to the ignition cylinder. You will need to cut the wires so that the computer doesn't 'see' the chip and the bypass resistor. The resisters go on the side that does not go up to the lock, it goes acorss the wires that go down to the connector which leads back to the pcm.
The steering colums was changed on my 2000 buick park avenue and it still wont start. do I need to get the security light to go off first
turn ignition on leave it on for 10 minutes then switch ignition off then you start the car
my 1993 buick park avenue wont start after i changed the front motor support you can jump it from the sodinoid and it will crank whats wrong could it be the security system
The Buick Park Avenue Started In 1991
how do i bypass the security code on my 1995 buick lasabre because my key is bad and i dont want to pay 185.00 for a key
I'm looking for help.The secority light is on car won't start.
give symptoms: any noises (if so describe), is security light on dash on, etc.
check crank sensor
start by taking the door panel off ....
Electrical problem, check batt cable connections to start
AnswerYes...wait at least 3 mins before trying to start the car again when this happens.....because the car WONT start for at least 3mins when the passkey system is activated...security light keeps flahing when turn keyon ... won let car start
That little black chip with the metal contact point in your key has to be in center of key and the contact points should be clean. If security light goes on and car doesn't start don't keep trying to start it, wait about 3 minutes for security light to turn off, and clean the contact points on the chip in the key and you should make sure it is not shifting to one side of the key.