It is called "the Light."
The head light bulb casing un-screws, like a half turn then just pops out. The bulb is inside that casing.
In an incandescent light bulb, air (Oxygen) leaked in and the filament (a wire) burns-well really melts. Halogens do this quite nice and LOUD.
peel bak the carpet in the he rear of the light assembly unit, there are two clips to be moved and the unit pops out. replace the bulb and reassemble
Dome cover most cars pops off with a screwdriver exposing bulb. Then you pull out, pry out, or push/turn 1/4 & pops out. No. should be on bulb base or owner's manual & just get same no. from auto parts store.
license plate light just pops out of the bumper with a screw driver.u can buy a new light at auto store or just change the light bulb
the housing contains the center break light and the speaker cover; it slides forward and pops up; check out your manual for details
I just did it! Open the tailgate and remove the top bolt and the bottom. The whole tail light just pops out. Whichever bulb is burned out, twist the plastic part and the bulb comes out easy! Pop in the new one and put it all back together! Super easy!
Open tailgate/liftgate and find the two bolts holding the brake light assembly. Remove the bolts and wiggle the assembly out. Turn the bulb bracket until it pops out and just pull the bulb itself out . Look at the new bulb its just a little bulb with no plastic if i remember it correctly. Kinda like a dome light bulb where it's all glass.
Remove the two rubber grommets on the inside and, with a flat-blade screwdriver, flick the spring steel catches inside, so that the light unit pops out of its seat, exposing the 18Watt wedge fitting bulb.
You have to go through the trunk. There should be a plastic panel that pops right off. just unscrew the round cable that the bulb is attached to and you can pull it out, replace the bulb, and pop it right back in. VERY easy. Hope this helps.
turn the bulb clockwise until it pops out unclip it put in new one and twist it back in tadaaaaa!
if its just the light bulb and not the whole lense assembly its simple pop the hood look at the backside of the headlight you will see a wire going to the headlight turn the plastic piece and the bulb pops right out.