answersLogoWhite

0


Best Answer

t55 torx t55 torx

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What tool do you need for the caliper bolts on a 2003 gmc Yukon Denali?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does a 2000 to 2003 Yukon Denali look like?

2003 Yukon Denali body style


How do you add transmission fluid to a 2003 Yukon Denali?

how do you check transmission fluid in 2003 yukon denali


How do you get brake pads off a 2003 Yukon Denali?

how to get rear brake pads off 2003 Yukon denail


Where are the caliper bolts on a 2003 Ford F-250?

The caliper bolts are located in the caliper... You should see two bolts on the inside of the caliper...


Where is the factory amp in a 2003 Yukon?

Under the cup holder assembly is where I found my amp in my 03 yukon denali


2003 Yukon Denali after multiple hard stops the brakes stick and the vehicle wont move.if you tap the brake pedal then the brakes release and you can move the vehicle again what would cause this?

sounds like a brake caliper piston is hanging up a little or slide bolts are sticking and need lubed


Where is the ac expansion valve on a 2003 gmc Yukon?

I anwered this question Look at post ... "Where is Expansion valve located on 2003 Yukon Denali XL"


What is the service ride control on a 2003 Yukon Denali XL?

how much it cost to fix service ride control for Yukon XL


What does service ride control mean in the 2003 Yukon Denali XL?

why does my service control light come on


The service ride control message is on in the 2003 Yukon Denali XL. What does this mean?

replace fuse or rear shocks


What size of wrench is needed to remove 2003 Silverado front caliper bolts?

the caliper bracket bolts use 18 mm wrench on a 03 1/2 ton 4x4


On a 2003 Pontiac Montana which caliper mount bolt has the rubber grommet the top or bottom?

Both the upper and lower caliper bolts must have the rubber boots on them. Otherwise, dirt and moisture will get in around the bolts and cause them to stick in the caliper mounts.