You will need rubber gloves, your new lights, and a screwdriver. You also will want to make sure you have a safe place to change it out and maybe someone along with you who can test it for you when you are done.
you don't replace the tail light you just replace the bulb in it
to replace tail light, you need to lower the tailgate> On the side of the bed that is covered by the closed tail gate are a couple of screws.Remove these screws and the tail light assembly can be removed.
On a 2012 toyota Highlander, How do you replace tail light Assembly
Then you need to replace it. Tail lights can burn out at different times. Aside from being dangerous, you can receive a traffic citation for a missing tail light.
In order to replace the rear window tail light you need to get into the truck. Once inside the trunk look to the top of the trunk and look at where the screws are for the rear tail light. Unscrew them and the entire housing for the light will pop off.
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
you can take the tail light out by unscrewing the wing nuts in the trunk, when all wing nuts are off pull the tail light out then take the light bulbs out to replace the tail light.
You can not, you will have to replace the entire tail light.
To replace a tail light on a Toyota Echo, you will first need to access the tail light assembly from inside the trunk. Locate the back of the tail light assembly and remove any screws or fasteners holding it in place. Carefully disconnect the electrical connector, then remove the old tail light. Install the new tail light by reversing these steps, making sure to securely fasten the assembly and reconnect the electrical connector.
You open the trunk and remove the plastic wingnut screw on the backside of the tail light and replace the bulb and put the nut back on...very easily done without tools...
I figured out the answer to the question I asked. You need to remove the tail light in order to get at the bulbs to replace. To remove the light, there are 4 screws that you need to take out- two on the outside and two on the inside behind the carpet. Its actually quite easy once you figure it out. Thanks.
How do you replace a broken tail light cover for a 2005 Nissan Pathfinder ?