starter on this car should be simple 12pt metric socket and wrench set range from 10mm- 19mm and a pair of jackstands or ramps
== ==
Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.
To replace the rear speakers, you have to go in the trunk, look towards upper back section of the trunk and you will see the speakers. The speakers have two black hand-screws that can be unscrewed without tools. It is as simple as this.
Disconnect the - battery cable Raise and support vehicle Disconnect the wiring at the top of starter Remove starter mounting bolts Remove starter
Probes were not made until 1989
remove batt. cable from starter(its not wired to batt so has no power) remove 2 1/2 bolts remove starter
You have to remove the intake manifold and be care full of the crank sensor
its located where the tranny bolts up to the motor. disconnect the three wires from the starter, then take the three bolts out of the starter and pull it out. just remember where the wires go!!
id say an hour
where would the spark plugs at on a Oldsmobile 1989 engine
There's a clutch on the starter that acts like a Bendix gear on a car. This clutch is stripped out on your bike. You'll need to pull the starter to replace it.
looking for the car code for a ninety eight 1989 oldsmobile