where would the spark plugs at on a Oldsmobile 1989 engine
The flasher on a 1990 Oldsmobile Ninety-Eight Regency Brougham is typically located under the dashboard, near the steering column. To access it, you may need to remove the lower dash panel. The flasher is a small, cylindrical component that usually plugs into the fuse box or is mounted nearby. Consult the vehicle's owner manual for specific details and diagrams for easier identification.
To change the spark plugs on a 1995 Oldsmobile Regency 88, first ensure the engine is cool and disconnect the negative battery terminal. Remove the ignition coil or spark plug wires, taking care to label them if necessary. Use a spark plug socket and ratchet to unscrew the old plugs, then install the new plugs, tightening them to the manufacturer's specifications. Reconnect the ignition system and battery terminal, and start the engine to check for proper operation.
how do change the spark plugs and the coil pack on a 2000 Oldsmobile intrigue
To change back3 plugs on 1997 OldsmobileI removed the alternator. It is a pain in the ...
don't have my manuel how many spark plugs are there in a 1997 cutlass supreme oldsmobile. need to change them all v6 engine. what is the best brand to buy thank you
To change the spark plugs on a 1997 Oldsmobile Achieva, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the ignition coil or spark plug wires from the spark plugs, being careful not to damage them. Use a spark plug socket and ratchet to unscrew the old plugs, then install the new plugs, ensuring they are gapped correctly. Finally, reconnect the ignition components and the battery terminal.
To change the spark plugs on a 1996 Oldsmobile Aurora, first, disconnect the battery to ensure safety. Remove the engine cover if necessary, then locate the spark plugs, which are typically beneath the ignition coils. Unscrew the ignition coils, carefully pull them out, and then use a spark plug socket to remove the old spark plugs. Install the new spark plugs, ensuring they are properly gapped, reattach the ignition coils, and reconnect the battery.
To change the spark plugs on a 1999 Oldsmobile Bravada, first, ensure the engine is cool and disconnect the negative battery cable. Remove the ignition coil or spark plug wires from the spark plugs, then use a spark plug socket and ratchet to carefully unscrew the old plugs. Before installing the new plugs, check the gap with a gauge and adjust if necessary. Finally, insert the new plugs, torque them to the manufacturer's specifications, reconnect the wires or coils, and reconnect the battery.
Bust your knuckles with the use of a mirror to see the plugs and a magnet to pick them up when they drop under the engine block!
The spark plugs are on the front and back of a V6 (back ones are tough to get to) L4 right in front. Turn the engine off and take off the spark wires unscrew the plugs
If your 1986 Oldsmobile Regency won’t start but is getting gas, the issue could be related to the ignition system. Check the spark plugs, ignition coil, and wiring for any damage or failure. Additionally, ensure the battery is fully charged and the starter motor is functioning properly. If all these components are in good condition, it may be worth investigating the fuel delivery system or any potential security system issues.
Sloppy timing chain? Bad tranny, the lockup clutch in the torque converter can cause jolting..