What truck brand ford or dodge or Chevy has the most powerful and reliable transmission and engine?
The Ford F-150 has the most powerful and reliable transmission and engine.
Need to know which engine and which transmission.
The Chevrolet Trailblazer SS would be a great, safe sports utility vehicle to purchase used. It comes with a powerful engine and has very high safety ratings.
Do it yourself engine transmission flush and filter change on 2005 Chevy silverado 5.3?"
4l60E or an r400 transmission
A 1991 Chevy Van has a 4 speed automatic transmission. The engine on the 1991 Chevy Van is a 4.3 L V6 and a 6.2 L Diesel engine is also available as an option.
Should be the 700R4 transmission.
Any Chevy transmission will bolt to any Chevy engine.
An autimatic transmission will have a 4 speed transmission and a manual transmission will have a 5 speed transmission.
As powerful as you want it to be, it all depends on much money you want to put into it.
NO it won't even bolt up to it. Chevy REDESIGNED THE ENGINE BLOCK AND TRANSMISSION BELLHOUSINGS in late 1999.
The 4L80E transmission
Make: Chevy Model: ?? Year: ?? Engine: ??
Yes it will, there the same.
looking for diagram of 5.3 liter v8 engine Chevy silverado truck transmission and torque converter?
Why a Chevy Big Block of Course.
All Chevy transmission will bolt right to it up to the year 1999. After that year Chevy REDESIGNED the engines and transmissions.
That is a 350 engine.
350 engine,transmission weighs about 560 lbs.
Generally the transmission dipstick is on the backside of the engine near the firewall.
That would be the 4L60E transmission.
Between the engine block and transmission. You will either have to remove the engine or transmission to get to them. NO OTHER WAY.
It depends on the transmission and any modifications to the engine.
The RPM is not working on 2002 chevy impala LS. transmission and engine sounds good- no problem. what's wrong
It's between the engine and transmission. It slides onto the input shaft of the transmission and bolts to the flexplate on the engine.
No, the engine is not the transmission bellhousing. The bellhousing is a separate piece all together.
I have a 1992 Chevy Camaro and I have 1995 Chevy caprice transmission and engine and I would like to put 1992 Chevy Camaro What should I do to make it fit?
Cut the engine capartment out so it fits
The transmission is bolted to the engine. The engine sits sideways, as compared to an older rear wheel drive car. the trans is on the left (drivers side) of the engine compartment.
On a 98 Chevy Tahoe, the transmission fluid pressure switch is located on the valve body. It is found to the right of the engine.
The transmission dipstick, On a 2008 Chevy cobalt, can be found at the back of the engine compartment, near the center. The dipstick handle will be bright yellow.
The transmission fluid fill cap on a 1989 Chevy school bus with a diesel engine is under the air filter. The air filter has to be removed to see it.
If you have an automatic transmission, check with the engine warm and running, The dip stick is located on the passenger side rear of the engine.
Why wont the 350 transmission from a 1979 Chevy truck with a 305 engine fit a 1981 Chevy truck with a 305 engine?
Who said it won't ? It will fit right in there with NO problems
This is an engine swap and will require engineering mounts, drive shafts, computers and wiring.
Depends on the engine, transmission, gearing, etc.
Depends on the year, engine, transmission, etc...
Should be the 700R4
You can tell if the transmission, in your 1998 Chevy Malibu, is going bad. If there is a whining or clunking noise. The transmission might cause your engine to install when you are stopped with your foot on the brake.
If it is a 2.4 liter engine with dohc it does not have a dip stick... it is a sealed transmission.
That would be a 4L80E automatic transmission.
Will a Chevy blazer engine fit in a Chevy s10 pickup
The engine stand bolts up to where the transmission bolts to the back of the engine.
I guess you can if you want. But I don't know WHY you would want to. the 700R4 is a MUCH better transmission. If you change, your fuel milage will be WORSE and the Engine will turn more RPMs. ( Hard on engine )
Will a 1986 s10 2.8v6 transmission work for a 1971 chevy pick up conversion from stick to automatic?
The 86 2.8L automatic transmission will not bolt up to a 71 Chevy engine.
The transmission dipstick is at the center rear of the engine comparment behind the distributor. This is how you have to fill the transmission fluid as well. DO NOT overfill the transmission fluid, that is the quickest and easiest way to damage a transmission. Transmission fluid is to be checked on a warm engine, idling in park.
yes and no yes in that it can be made to fit no in that a Chevy transmission has a different bolt pattern than Oldsmobile's, Buick's, and Pontiac's. the motor mounts are also probably going to be different. However you can change the motor mounts and there are companies that make adapters to use a Chevy transmission with a Oldsmobile, Buick, or Pontiac engine. I have seen an adapter to use a ford transmission with… Read More
The 1997 Chevrolet express 7.4 liter engine should never have transmission fluid point into it. The engine holds 6.4 quarts of motor oil. The transmission holds nine quarts of transmission fluid.
The Chevy 283 engine has the standard bellhousing configuration and is compatible with transmissions that bolt to first generation small blocks. The automatic TH350 transmission will fit the 283 engine.
If it is a automatic its is the hydramatic 4l80e if it is a manual transmission it is a v 4500
checking transmission fluid 3.1 ltr
Assuming this is a truck, if it has a standard transmission, TDC. If it has a automatic transmission, 4 degrees BTDC.