Want this question answered?
Yes refrigerant temperatures and pressures in the cooling mode of a heat pump is the same. They are both in the suction side and the discharge side of the system.
No, the liquid (discharge) line is the high pressure side. The suction line is the low pressure side.
oppisite side of txv sensing bulb on outlet of evaporator (suction line)
Frist putt of the main incomer HT side then Rack out the breaker and put the LOTO after that Discharge the cable Both side (HT/LT).
As the nanorobot do not generate any harmful activities there is no side effect. It operates at specific site only.
The condenser is on the high pressure (discharge) side of the system.
The discharge line does not go back to the evaporator but instead it goes to the a/c condenser......
The low side service port is located on the suction hose coming off the rear of the a/c compressor and the high side is located on the discharge hose coming from the condenser.......
When the points are wearing on one side, which means it it over or under capacity. Also a good condenser would have a reading of 18 to 23 microfarad's
Yes. The condenser is on the high side, and high pressure vapor goes from the compressor outlet directly to the condenser inlet.
Discharge side........
These are terms used by refrigeration and air conditioning techs. The suction is refrigerant returning to the compressor from the evaporator, or the low side. The high side is the discharge or head pressure, where high temperature high pressure gas leaves the compressor to flow into the condenser. These systems should only be worked on by licensed and experienced techs.
The high pressure side.
The condenser does not have a drain line. The evaporator drain is on the lower passenger side of the firewall.The condenser does not have a drain line. The evaporator drain is on the lower passenger side of the firewall.
air conditioner condenser is in front of radiator ignition condensor should be in side the distributer cap or on side of distributer
It has an internal blockage! Air conditioning gas cools as it expands (as it changes from liquid to a gas). It is meant to be a liquid in your condenser but if your condenser has a blockage (say some dirt or other contaminent) then the liquid loses pressure on the other side of the blockage and becomes a gas. This makes your condenser really cold and frosty on the outside!
It's on the high side.