0
What two copper lines connect the evaporator section with the condensing unit?
Wiki User
∙ 8y ago
suction line liquid line
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
Can you connect copper to galvanized using only a bronze fitting?
There are copper fittings that will connect to galvanized.
How do you connect copper pipe?
YOU thread or braze copper pipe Copper tubling you solder, braze, flaire, compression ring, mechincal joints
You want to replace old lead pipe connected to cast iron sewer pipe with copper How do you connect the copper pipe to the old lead pipe or to the cast iron pipe?
When I have to connect copper to lead "D" I usually solder the copper to the lead or wipe a lead joint depending on the diameter To connect copper to cast iron ,.... If there is a hub I caulk the copper directly into the CI with oakum and poured lead (molten) OR one can solder / braze a female adapter fitting and screw the copper into a CI female fitting
You want to connect a male PVC fitting to a copper pipe?
Sweat a female fitting on the copper or use a compression coupling between the two.
How do you connect Copper pipe to PVC?
You can often find a modern connector such as Sharkbite or Qwest fitting to do this.
What are typical evaporator tubes made of?
Copper
Can you connect copper to galvanized using only a bronze fitting?
There are copper fittings that will connect to galvanized.
What is the common material used for evaporator tubing when using fluorocarbons?
copper tubing
What is the line side on central air unit?
Do you perhaps mean the 'lineset'? If so, it is usually a copper line (actually 2 copper lines) running counter-currently. They connect the indoor evaporator coil (above furnace or air-handler) to the outdoor condenser. One tubing carries the refrigerant gas from the indoor evaporator coil to the outdoor condenser and the other line carries the condensed (liquid) form of this gas back to the evaporator coil for it to be evaporated again and be converted back to gas. This is the refrigeration cycle of an A/C unit.
How do you connect copper to copper?
A covalent bond. or just hit it
How do you fix the copper line from the condensing unit if it has been dripping what looks like water?
Nothing. It is water and it's supposed to do that.
Why do you use copper wire to connect all your components?
Copper is an excellent conductor of electricity.
How do you make a Still?
A still consists of a boiling chamber connected to copper tubing at the top. The tubing runs into a condensing chamber. The boiling chamber should be sealed s so that the only way out for the steam is through the condensing tube.
Can you connect a copper p trap to PVC?
Yeah you can
How do you connect copper pipe?
YOU thread or braze copper pipe Copper tubling you solder, braze, flaire, compression ring, mechincal joints
How do you connect the coil to the evaporator coil in a split system air conditioner?
In a split system air conditioner the evaporator coil, which is right next to the furnace blower is connected to the outside "condenser coil" by two copper lines called a "line-set. The larger of the two carries the refrigerant in its vapor state and the smaller of the two carries freon in a condensed or liquefied state. The brazing of copper line sets is done by means of an extreme high temp oxy/acetylene welding torch and is a much more involved and complicated process than water pipe (copper) brazing. As much as I hate to say it, "don't try this at home!
Can you connect brass fitting to copper fitting by soldering?
Sure why not
