Want this question answered?
Not normally. An elaboration of what circuits are in the conduit and what type of conduit it is would be useful, though, and necessary to give a definitive answer.
9 - Is this a test answer or do you just want to know for a project you're doing? Take a look at NEC chapter 9 - tables 4 and 5 (in the 2005 edition at least)
NEC code table C10 has conduit fill charts. google for it. Per the table, 1 1/4" inch conduit can support 7 #4 cables. The 1 inch conduit allegedly can support 4 cables but it will be very tight and I would go for the extra room in a 1.25" conduit.
4/0 gauge wire, depending on its insulation type is rated from 230-260 amps. Assuming you are running a new power supply with the 4/0 wire, you will have a minimum or three 4/0 conductors and a ground wire for a single phase power supply and four conductors with ground for a three phase power supply. Three 4/0 wires require a minimum 2 inch conduit. Four 4/0 wires require a minimum 2 and 1/2 inch conduit. These conduit sizes I'm quoting come directly from the NEC, the National Electric Code. These sizes of conduit are determined by the basic rule that all the conductors in a conduit are not to exceed 40% of the volume of the pipe. The other 60% of air space is required for heat dissipation.
The type of conduit system is governed by two factors. One the code book states what type of system can be places in what specific locations. The second factor is what the electrical engineer specifies that what he wants the conduit system to be on his project. EMT is used in the majority of jobs for industrial and commercial projects. As a conduit system it is easy to install and more circuits can be added to the system very easily abiding by the code book rules for conduit fill.
what type of wire is it? Cable ,Phone, electric.
In the true definition of a conduit yes a steel sleeve is in that category.
Not normally. An elaboration of what circuits are in the conduit and what type of conduit it is would be useful, though, and necessary to give a definitive answer.
9 - Is this a test answer or do you just want to know for a project you're doing? Take a look at NEC chapter 9 - tables 4 and 5 (in the 2005 edition at least)
There will be at lease three and on some conduits additional information. There will be the manufacture's name, type of material the conduit is manufactured from and the diameter size of the conduit. For example Scepter PVC 100 mm (for American customers 4") conduit.
Conduit is just a medium to get the wires from one place to another. There is no voltage restrictions in low voltage wiring (750 volts or less). When it comes to conduit fill, electricians are governed by the electrical code conduit fill tables. The conduit is sized to accommodate the conductor size for a specific load.
If the existing conduit has not been intentionally or accidentally interrupted it is still an adequate ground. If you are in doubt about this or if a test proves that it is not grounded, new conductors including a new ground wire can be pulled inside the conduit. If the existing conduit is flexible conduit and it has "jake" type twist connectors, rewiring with a ground is advisable as those type of connectors do not maintain a good ground connection.
it all depends on the type of games you like....
PVC is cheaper but is used differently. PVC is usually baried in ground and emt usually runs exposed. You can use PVC exposed if it is schedule 80 gray PVC electrical conduit. Schedule 40 is for under ground
yes with any type of light
Xurkitree is an Electric-type.
Not at all. It's just a common (and rather weak without a Light Ball) Electric type.