series circuit
To design a circuit so that lights can be turned on and off separately, we connect the circuit in parallel.
Parallel circuits.
If you mean Christmas lights; that was before. Nowadays Christmas lights are connected in parallel.
It is a resistive type of circuit.
both
If you remove one light from a chain of lights, and the other lights turn off, then it is a 'series' circuit.
If the lights are the load of the circuit, then the lights will be off if the circuit is open.
The lights are wired in parallel.
Hootie's
Often this type of behavior is caused by a bad ground for the lighting circuit. Check the ground circuit for the brake lights.
fairy lights aremade out of many small lights. the lights are like the lights you put on a Christmas tree, but smaller. they are filled with gasses used in go green light bulbs.
This is the case in a series circuit. (like the small Christmas lights.)
Lights are on in closed circuit. It means that is a current flowing when circuit is being closed.
The circuit breakers in a panelboard feed separate circuits. The lights that stay on are on a different circuit than the ones that go off. To fine the circuit that feeds the lights that stay on, go to the panelboard and turn off the breakers one by one until the lights go out. This is the circuit that feeds that circuit of lights. Remember that lights and receptacles can be on the same circuit together.
A parallel circuit. All the lights are connected in parallel across the power source.
its a series connection