0
What else can I help you with?
What part of camera lens lets light through?
The iris (technically the diaphragm) lets light from the lens enter the camera. The entire lens can let light fall on the film or sensor. But, much of the time it doesn't do that. An device called an iris makes the hole through which light passes larger and smaller. When all the way open it lets light from the entire lens reach the film or sensor, but it can make the hole smaller and only allow light from a part of the lens enter.
How does shutter speed work to control the amount of light that reaches the camera sensor?
Shutter speed controls the amount of time the camera's shutter is open, determining how much light reaches the sensor. A faster shutter speed lets in less light, while a slower speed lets in more light.
Jeep liberty Part time light stays on why?
There is a malfunction in the circuit that runs the light. Could be with the switch on the transfer case, in the wiring, or in the cluster.
HOW TO TURN OFF DOME LIGHT ON A MONTE CARLO?
The year Monte would be helpful. Late model vehicles usually have a switch that lets you select, on all the time, off all the time or on only when doors are opened. Consult the owners manual.
What is the only time that light waves travel at the speed of light?
Light always travels at the speed of light. The only time that's 299,792,458 meters per second ( " c " ) is when it's traveling in vacuum.
When compared in a given time interval with other light bulbs connected to a 120 V circuit a 60 W lightbulb?
A 60 W light bulb consumes more power (produces more light) than a 40 W light bulb in a given time interval when both are connected to a 120 V circuit. This is because power is directly proportional to the wattage rating of the light bulb.
What will happen to the light bulb when you switch off the electric circuit?
When you switch off the electric circuit, the flow of electricity to the light bulb will stop, causing the filament in the bulb to cool down and stop emitting light. The bulb will go dark until the circuit is switched back on.
Can you shut off one appliance at a time on a parallel circuit?
Only if you install separate switches for each part of the circuit. The whole point of a parallel circuit - is that both parts of the circuit are controlled by the same switch.
Can light go through stained glass window?
it is translucent because it lets the light shine through
How is adding a ammeter to a circuit different from adding a light bulb?
When you add a light bulb, you are adding a load, which performs a function - in this case, it converts electrical energy to light and heat energy. When you add an ammeter, most of the time you intend to measure the current in the circuit, which is the function of the ammeter. Thus the two electrical components differ in their function and does different things when added to a circuit.
Why can't light be in 2 mediums at the same time?
Light can only be in one place at a time, when measured.
Why does your battery drain on your 1981 corvette and you have trouble starting it?
Weak battery unable to hold a charge? Hidden accessory left on? trunk light under hoiod light etc.? Excessive parasytic load? Bad voltage regulator not opening circuit on shutdown? Install a test light in series with the - battery cable - if there is a draw light will illuminate. Disconnect fuses one at a time until light goes out indicating which circuit is drawing current and then investigate that circuit
