0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
1991 Nissan 240SX transmission removal?
take out the halfshafts pull the motor and unbolt the tranny
How do you take off the intake manifold of a 1990 Nissan 240SX KA24E to replace the head gasket?
you have to take the throttle body support bracket loose. it is under the bottom mounted to the engine. you cannot remove it otherwise. I know as i did the same.
How much oil does a 1991 Nissan 240SX take?
4.2 quarts from empty to full. Put it 4 quarts, start motor, idle for 30 seconds, turn off motor and check dipstick, fill to the line marked "full"
My Nissan 240SX 1990 model is ticking what could be the problem?
Valve lifter could be sticking. Take the valve cover off and start the engine. You can narrow down which one it is. Might Not be sticking and just need adjusting.
Where is the oil drain plug on a Nissan 240sx?
Try looking on the oil pan. If you still can't find it then just take it to a shop.
How do you flush the radiator on a 1990 Nissan 240sx?
there is a plug on the bottom of the radiator, pull it. what i do is take the whole thing out and you a garden hose and flush it out like that.
How do you fix the hood on a 1990 Nissan 240sx?
Running into a tree works well. Hammers will also do the trick, but take a little more time.
What kind of transmission fluid do you need for a 1996 Nissan 240sx SE?
all newer models take Dexron III transmission fluid
How long does it take to change a 1989 Nissan 240sx brake master cylander?
maybe 30 minutes, just be careful and follow instructions or you'll have to bleed the whole system
How do you replace the front turn signal bulb located on a 1993 Nissan 240SX?
one screw holds the light on, take it off and spin the light lens holder to remove the bulb
What spark plug does a Nissan h20 4 cylinder engine take?
Bpr4es
How do you change the rear brake pads on a 1990 Nissan 240sx?
take caliper off, and then remove brake pads... piston for the brake caliber must be spun in to reset it. dont try to puch it in, it will not move...
