A VRS sensor and you can measure it with a DVOM on A/C Votlage by probing both wires and cranking the car.
It is a VRS sensor. You set the DVOM to AC and back probe both wires. (Wyo Tech student)
Change the plugs and wires. also check the throttle position sensor or have it tested
Typically you put all the wires in one raceway to utilize a shared neutral or ground wire.
A 4 wheel abs would have sensor wires running to the front wheel bearings.A 4 wheel abs would have sensor wires running to the front wheel bearings.
what wires on a Volvo s60 2.4 turbo air mass flow sensor (4-wires) would use to install a performance chip
If you are replacing a 02 sensor with a new one I would cut off the wires at the sensor and slip a 7/8" box wrench over the sensor and remove it with a counterclockwise motion.
this sensor sould be located on the inrake, look for your air box where the air filter is on the box or around it sould be a sensor on it you would notice by the wires cliping on to the sensor
If the sensor is not to be used again I would disconnect the wires leading to it then cut the wires off at the sensor. Now you can slip a 7/8" box wrench over the sensor and remove it by turning it counterclockwise. Install the new one using a 7/8" open end wrench.
its connected with the mas sensor and is toward the top on the right side of the airbox, it has 6 wires going to it its connected with the mas sensor and is toward the top on the right side of the airbox, it has 6 wires going to it
If you are replacing it with a new one, unplug the sensor from the harness, cut the wires off at the sensor, slip a 7/8" box wrench over the sensor and with a counterclockwise motion remove the sensor from the exhaust pipe. Install the new one using a 7/8" open end wrench and tighten as you would a spark plug, reconnect the wires to the harness.
Most common cause would be a faulty wheel speed sensor or damaged wires.
If you have the room I would cut the wires off at the sensor and slip a 1/2" drive, 6 point, 7/8" deep socket with a long breaker bar over the sensor.