answersLogoWhite

0

If the sensor is not to be used again I would disconnect the wires leading to it then cut the wires off at the sensor. Now you can slip a 7/8" box wrench over the sensor and remove it by turning it counterclockwise. Install the new one using a 7/8" open end wrench.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you adjust a throttle position sensor on a 2003 jeep wrangler?

The tps is not adjustable on a 2003 Jeep Wrangler.


How do you unplug an oxygen sensor on a 2003 Chevy Cavalier?

How do you unplug an oxygen sensor on a 2003 Chevy Cavalier


Where is the battery temperature sensor on a 2003 jeep wrangler?

Underneath the battery.


How do you replace a 2003 Kia Spectra throttle position sensor?

How to replace throttle sensor kia spectra 2003


What should it cost to replace the oxygen sensor in a 2003 Chevrolet Impala?

The sensor is about $75.00 to $100.00 and the labor is 1/2 hour with 1 hour diagnostics. It is best to have the diagnostics done as you may not have a bad oxygen sensor. It could be as simple as a vacuum leak.


Can you replace the Coolant Level Sensor in a 2003 deville?

No, you have to replace the complete tank which includes the sensor.


What does O2 Sensor Heater Circuit Malfunction Bank 2 Sensor 1 on a 2003 Chevy S-10 pickup indicate and it's location to replace?

The Exhaust Manifold Oxygen Sensor needs to be replaced.


What does a P0123 diagnostic code mean for a 2003 Jeep Wrangler?

Bad throttle position sensor


How do you replace the fuel sensor in a 2003 Grand Prix?

replacing a fuel sensor on a 2003 grand prix?


How do you replace the oxygen sensor on a Renault Clio 2003?

its located just before the catalyst. Unlplug it then using an oxygen sensor socket carefully undo it. it will be very very tight due to the temperatures it experiences, be careful incase you shear it off!


How do you replace the oxygen sensor on a 2003 Toyota Matrix?

Find very good instructions with photos at: http://matrixowners.com/topic/72977-diy-how-to-change-an-oxygen-sensor-in-a-matrix/ I used them and they are easy to follow. Replacement time 15 minutes.


Can you replace the hard top with a soft top on a 2003 jeep wrangler rubicon?

Yes