0
voltage
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What voltage segregation is required within panels?
Between power and control voltage circuits
Analysis of digital and analog circuit?
Analog circuit continuous uses the time voltage and currents while digital circuits are sometimes called the on/off and high/low control of voltage in circuits.
What are the different ripple removing circuit which one is better and why?
1.control circuit is used for removing ripple 2.analog circuits are also used with TPS84259 negative output voltage power module to reduce the ripple
What is 1v in circuits?
That refers to the voltage.
What determines circuits capacity?
The difference of voltage
What voltage segregation is required within panels?
Between power and control voltage circuits
Zener diode application?
A zener diode are used in small circuits as shunt regulators to control voltage. It may also be used as voltage references and as surge protectors to limit transient spikes in voltage.
How do 480 volt control circuits work?
Some control circuits remain at line voltage but most use a reduced voltage of 120 volts. This is acquired by the use of a control transformer 480 primary to 120 volts secondary.
Do relays use high voltage to control low currant circuits?
Low voltage to operate relay controlling high CURRENT circuits (currant is a dried fruit).
What is Application of clampers circuits?
it is used in voltage multipliers.
Analysis of digital and analog circuit?
Analog circuit continuous uses the time voltage and currents while digital circuits are sometimes called the on/off and high/low control of voltage in circuits.
What other circuits are on the alternator circuit?
May be the Voltage controller circuit. Control the voltage for charging, and cut off when full charged.
What is used to measure potential difference inparallel circuits?
A voltage test meter is used to measure voltage potentials in a circuit.
What is voltage stabilizer and what's it's control system circuit?
Voltage stabilizers are the circuits that are used to filter noise from the source voltage. DC voltage generated from a bridge network or diode network will contains voltage glitches. These glitches may cause serious problems to the operation of digital circuits. So a voltage regulator is used to filter these glitches. voltage stabilizer can be built using a voltage regulator ICs like 7805 for +5V, 7809 for +9V, 7905 for -5V, 7909 for -9V and so on.
What is the effect of surge arrester on increase the voltage in medium voltage circuits?
What is the effect of surge arrested on increase the voltage in medium voltage circuits?
What are the 2 advantages of 24 Volt current?
Low voltage circuits are any circuits under 30 volts, usually 24 volts. 24 volt circuits are usually control circuits. The amount of current in these systems is usually small, under 5 amps. Since the voltage and amperage is very low, wiring can be much smaller and therefore much cheaper to install than "line" voltage wiring. Low voltage is also much safer.
How do you trace electrical circuits with no neutral?
In large control cabinets the test leads of the testing equipment sometimes are not long enough to stretch from the control transformer X2 terminal to the circuit that needs to be tested for voltage. If you have a control transformer for the control voltage, ground the X2 terminal of the transformer to the control panel enclosure. Tracing circuits now becomes easy as one lead of the tester can be used to test for voltages while the other test lead can be taken off of any metallic structure of the enclosure that the control circuitry is enclosed in.
