obsolete
CALL THE DEALERSHIP
A competent HVAC Contractor in your area
Yes, immediately and ask for advice.
what do we call a pilot in hindi
The person is a pilot.
Check if your pilot light is on. If it is, then there is a fault in the gas regulator and you will need to call a gas technician.-If the pilot is off, The detailed directions are printed on front of EVERY gas regulator. - However, in general terms, turn regulator switch to OFF for 2 minutes, then to PILOT and depress for one minute, then light pilot or press clicker till it lights. Keep PILOT pressed for 2 more minutes then slowly release it. If it stays on then turn main switch to RUN or ON. Use a barbecue match (12 inch long) to light manual pilots. -If the pilot will NOT stay on, then you have a faulty thermocouple. - Not a complicated job. Call a competent handyman or gas tech.
You don't. If the heater has an electronic spark, then it doesn't have a standing pilot to light. The spark lights the pilot when there is a call for heat, which in turn lights the burners. If the heater is on and the pump is RUNNING, the heater should light automatically when the water temperature is lower than the heat setting.
High winds, pilot generator. Is the heater located next to a wall? Is the heater door closed? Does the heater have a draft hood or what they call a stackless heater? Ken
A "Pilot" is a person who drives a plane.
telephone
Of course. Isn't that why it's called a "Pilot"? No ... Pilot is what they call an ad
It is necessary to keep the button depressed for about one minute after lighting the pilot light, to heat an element that keeps the pilot valve open. If the pilot light does not continue burning after the button has been released, you should turn the control to the "off" position and call a service technician or your gas supplier. Normally you have to hold the "pilot" button down for TWO minutes and then release if it doesn't maintain the pilot call a Licensed plumber NOT A TECH and ask to see the license for your protection and the LMP will replace the thermo couple and check to the flue for proper up draft and make sure you have complete combustion Many contractors trying to beat licensing laws say "we are sending over a tech" as this is dishonesty of the highest caliper because they do not advertise under "tech" in the phone books or Internet