Nothing much will happen except the same bulb will not blow..
you can go to a auto shop and buy a rx300 bulb and after you can get someone to remove the headlight and you can remove the bulb and put the new one.
Remove the old bulb and you will know the correct one to buy.
That bulb goes out. The other bulbs remain on.
remove the old bulb and keep the new one instead
To change the headlight bulb you do not need to remove the headlamp assembly. Pop the hood and behind the assembly is access to the light bulb, just unclip it and carefully pull it out from the hole. Then you can remove the old bulb and put the new one in. Don't touch the light bulb! It won't work if you do.
You can install a microscope bulb by using a screwdriver to remove the old light bulb and then replacing it with a new one. Be sure to review your owners manual to find out what type of bulb is used in the microscope.
You will have to buy a new bulb,then remove the old one and replace with new.
To replace the bulb for the interior light of a car, one should remove the lens cover, remove the burnt out bulb, inspect the socket for dirt or corrosion, inspect the lens cover for damage, check for loose wires then install the new bulb and replace the cover.
remove some screws and then take the old bulb to pep boys
I was able to remove bottom of driver side dash board. Who do you remove to top. Need to fix one bad light bulb.
Remove the wing nut from the front turn signal/side marker/park housing mounting stud and remove the housing from the fender. To remove the bulb holder, depress the tab next to the bulb holder, turn the bulb holder counterclockwise andremove it from the housing. Remove the old bulb replace with a new one and install it the reverse procedure of removal. I hope this helps you out.