0
a short or too much resistance thus heat
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why doesn't your remote wire turn on your amp anymore?
Easy way to check were the problem is take a 6" piece of wire. Unhook the remote wire from your amp. Then hookup your 6" piece of wire to amp remote terminal then take other end and connect to the 12+ terminal. If amp powers up the its in the headunit. If amp does not powerup or goes into protect mode the amp is problem.
Can you use a 20 amp fuse for a 15 amp surge protector safely?
No. If you use a larger fuse you are not protecting the device which has a rating of a lesser value.
Why does your guitar amp blow fuses when you replace them?
Don't know too much about amps, but fuses generally blow to protect equipment. A large surge of power can cause this or if the wrong size is replaced. DO NOT go with a larger fuse. You could kill your equipment forever or start a fire. Call the company that makes your amp.
In a 120V 24A circuit what amp fuse is needed to protect it?
30 amp
Is it possible to use op amp in open loop mode?
Yes, but it is not very useful in open loop mode. In open loop mode, unless you happen to be very lucky (as in extraordinarily lucky, meaning you won't be) the output will be pegged to one of the two rails. The op-amp will be operating in saturated mode instead of linear mode, and its response time will suffer. You could also damage the op-amp.
What does is mean when the protect light comes on your amp?
The impedance is to low causing the amp to shut down
Is it possible for an amp to go into protection mode from overheating?
yes...yes it is
What is a fuse T5AL?
A T5AL is a tubular 5 amp 20mm x 5mm Slow Blow Anti Surge glass fuse.
Can you replace a 20 amp fuse with a 10 amp fuse?
NO! Using a larger amp fuse defeats the purpose of the fuse to protect the wiring in the circuit. This can cause a fire. Always use the correct amp fuse for that circuit.
Can you replace a 10 amp fuse with a 20 amp fuse?
NO! Using a larger amp fuse defeats the purpose of the fuse to protect the wiring in the circuit. This can cause a fire. Always use the correct amp fuse for that circuit.
What is the effect of the op amp in the circuit?
So long as you remain with the range of the device (power supply rails less a volt or two), the output of an op-amp will go to what ever value is required to maintain the input stages (bridge) to remain the same. So, the effect on input voltage on output of an op-amp is dependent on the feedback circuit.
How do you wire a dual voice coil to an amp?
If you want to run both coils,you have to wire the positive to positive and negative to negative on your sub,then run a wire from each plug to the amp. Positive to the positive side of the amp and negative to negative side of the amp,(you can run in bridge mode or stereo if your amp can handle the load)
