increase drive pulley size
Increase drive pulley size
coom
Assuming you mean using smaller piping in a compressed air system-- answer is no, the air pressure does not increase. In fact, the air pressure measured at the end of the line will be lower due to increased pressure drop in the smaller lines from the compressor. The air velocity in the pipes will be higher because of the reduced inside area of the lines, but the actual pressure will be lower at the exit. An air tool at the end of the line would be less powerful.
centrifugal pump uses centrifugal action while reciprocati pump operates on resiprocating motion of pistonA centrifugal pump will typically give you a higher flow rate but a lower pressure, where a piston pump will give you more pressure but a lower flow rate.
I had the same problem but the compressor would shut down from over heating. It turned out to be the pressure relief valve leaking. Listen for leaks. I ordered a new valve but never installed it because it turned out that mine was just stuck. Once I freed it, it has worked fine since. Also : The compressor is not shutting off because it is not reaching the shut off pressure. Check for air leaks. If it will not develope more than 60 psi, it may be worn out.
The head pressure and compressor current would normally rise (strong winds and/or rain and/or very low air temperatures will reduce this effect). Less heat would be removed from the refrigerant and therefore deliver less cooling.
A ball park figure for the weight of a double decker bus might be about 15,000 kilograms. But to calculate the centrifugal force on a turbine blade with this hanging from it would require the blade length and the rotational speed of the turbine.
A bevel gear is used to increase speed.
It would increase your speed.
it would increase your speed in direct proportion. If time is halved, for example, speed would double
somewhat you would usually use all of your leg including a nudge from the heel if nessesary to increase the horses speed
No why would the speed of sound will stay the same
Short Answer: Because it takes power from the engine to operate the A/C compressor. More detailed answer: Under a given load, an engine will operate at a given speed when a certain amount of fuel is provided. If you don't increase the fuel, but you increase the load (by turning on the A/C compressor), something has to give, and the engine operates a bit more slowly. Therefore, you would have to press on the gas just a tiny bit more to get the engine to operate at the same speed, which necessarily means you're using a bit more fuel.
The wavelength would increase in direct proportion to the speed.
An equation that relates three basic quantities for waves in general is:speed = wavelength x frequency In this case, if you increase the speed (without changing the wavelength), the frequency would have to increase; on the other hand, if you increase the wavelength (without changing the speed), the frequency would go decrease.
No.
increase temperature use a catalyst increase concentration increase surface area of what you are reacting (crushing into a powder)
Flaps would increase drag increasing your speed will increase it even more
Speed of sound would increase as the temperature of the air increases Speed of sound increases as humidity of air increases Speed of sound is affected by the density of the air. As density increases velocity of sound decreases