define the maximum value of an ac wave form
maximum or peak value
Latching current is the current flowing between anode to Cathode when thyristor is turned on using gate pulse. If the gate pulse is removed before the required min amount of latching current value is not reached thyristor will turn off. To keep the thyristor in on state the gate pulse duration should be so adjusted that the min latching current value is reached before it ends.
Capacitors resist a change in voltage, proportional to current and inversely proportional to capacitance. In a DC circuit, the voltage is not changing. Therefore, after equilibrium is reached, there is no current flowing through the capacitor.
Distortion can be caused by many things, and varying levels. Two of the most common are;- Clipping. This is when the amplifier has reached maximum or minimum amplification and causes the wave form, to be flat top and bottom. It squares the waveform and sounds rough. Usually due to the input signal being too high. Harmonic. This is a form of feedback, where the input is receiving signal from the output. Sometimes the amplifier 'rings' at a harmonic of the input and is re-amplified giving a tinny, squeaky, sound. Caused by bad screening or component layout.
It is the CE (collector - emitter) voltage at a given collector current when the transistor is fully on. Increasing the base current will not lower the CE voltage any more once saturation has been reached.
Nope, never, absolute zero cannot be reached by artificial or natural means.
Nope, never, absolute zero cannot be reached by artificial or natural means.
The maximum negative pressure in isolated system is negative ATM. ATM is the pressure created by air molecules and it is 1.01325*10^5 Pa. So a negative pressure of 1 ATM means absolute vacuum.
It can't be reached. However, scientists have managed to approach absolute zero within less than one microkelvin.
Maximum CNS effects are no9t reached for about two hours , but can begin with in 30 mins
me
Maximum entropy is when thermal equilibrium is reached and no further vaporisation is possible.
After breakdown voltage is reached in a zener diode the current increases drastically.
True! :)
yes, that's right.
amplitude
The time taken by the ball to reach the maximum height is 1 second. The maximum height reached by the ball is 36 meters.