answersLogoWhite

0


Best Answer

either both bulbs burnt out highbeam only or you need a headlight switch (controls signals, cruise(if it has it), and headlights)

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause Brights not to work on a 1990 Chevy Corsica?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would a 1995 ford Corsica starts but stalls when you put it in gear?

Because its a Chevy corsica not a ford corsica!!!!!


Where do you find the fuse for the fuel pump on a 1995 Chevy Corsica?

where would i locate the fuse for the fuel pump on a 1995 Chevy corsica


What would cause a 1996 Chevy Corsica to idle high then idle fine after turning the engine off and on again?

check the soleinoid


What would cause a puddle of coolant in the passenger side floor of a 92 Chevy corsica coolant leak?

Leak in heater core


What would cause puddles of water on the floor of a 1996 Chevy Corsica?

Heater core is leaking. Air Conditioner drain hose is plugged.


What would cause a 95 Chevy corsica to act like it is stalling when you hit the gas to accerlate?

could be the catalytic converter or it might need a new transmission.


Would you show you owners manual for 1996 Chevy Corsica?

Why not? Do you have some dirty pictures in it?


How do you repair a 1994 Chevy Corsica?

Push it off the wharf would be a good start.


Why would both headlights suddenly go out on a 1993 Chevy Corsica?

Check the Fuse and/ or relay.


Why would the plug gap on a 1993 Chevy Corsica be 060?

Because it has HEI (High Energy Ignition).


My 1995 Chevy corsica's rocker panels are starting to rust Would I be compromising the frame to fix this?

Fixing the rocker panels on a 1995 Chevy Corsica will not compromise the frame. Fixing this will help the vehicle last longer as far as rust goes.


What would cause the rear right break on a 1996 Chevy Corsica to pop when releasing the pedal after a stop?

Mine is doing that. I have a '92. I have not looked into the matter yet but I believe it is a wheel cylinder that has a sticking piston.