change the pickup coil in distr
A 1998 Dakota does not have a ballast resistor.
Behind the battery.Behind the battery.
To adjust the ignition switch linkage on a 1988 Dodge D-100, first, ensure the vehicle is in the "Off" position. Remove the steering column cover to access the ignition switch and linkage. Loosen the mounting screws for the ignition switch, adjust the linkage until it aligns properly with the ignition cylinder, and then retighten the screws. Finally, reassemble the steering column cover and test the ignition switch for proper operation.
A 1988 Dodge van would have throttle body fuel injection.
Yes, buy the Haynes Repair Manual.
Ignition switch and lock cylinder removal 1988 Dodge Ram 50.Disconnect the negative battery cable from the battery.Remove the steering column cover to gain access to the ignition switch/lock cylinder.Using wire cutters, remove the cable band.Remove the bolts that hold the ignition switch/lock cylinder to the steering column.Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
Hey; Check the ballist resistor, and the voltage regulator. Unidrv
how to do ignition timing on 1988 Toyota corolla fx
How do i change the ignition switch in a 1988 Chevy camaro
what is the ignition timing for a 1988 Chevy 454 engine
no it wont cause the engine mountings are different
electronic ignition