answersLogoWhite

0

Ignition switch and lock cylinder removal 1988 Dodge Ram 50.

  1. Disconnect the negative battery cable from the battery.
  2. Remove the steering column cover to gain access to the ignition switch/lock cylinder.
  3. Using wire cutters, remove the cable band.
  4. Remove the bolts that hold the ignition switch/lock cylinder to the steering column.
  5. Unbolt and remove the key reminder switch and remove the switch lock cylinder from the steering column.
User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you remove the ignition switch in a 1988 Isuzu pickup?

how to remove lock cyliner switch 1988 Isuzu pickup


1988 dodge D-100 ignition switch linkage adjustment?

To adjust the ignition switch linkage on a 1988 Dodge D-100, first, ensure the vehicle is in the "Off" position. Remove the steering column cover to access the ignition switch and linkage. Loosen the mounting screws for the ignition switch, adjust the linkage until it aligns properly with the ignition cylinder, and then retighten the screws. Finally, reassemble the steering column cover and test the ignition switch for proper operation.


How do you change or fix an ignition switch on a 1988 Corsica when the key turns but does not actuate anything?

If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.


How do you change the ignition switch in a 1988 Chevy Camaro?

How do i change the ignition switch in a 1988 Chevy camaro


How do you remove the ignition switch key lock on a 1988 Jeep Cherokee?

Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.


How do you remove the ignition switch on an 88 Pontiac Bonneville?

I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.


How do you install ignition switch 1988 gmc truck?

You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.


How do you remove ignition cylinder from 1988 Chevy pickup?

Remove the steering wheel. (you will need a steering wheel puller) Remove the turn signal switch. It is not necessary to completely remove the switch from the column. Pull the switch rearward far enough to slip it over the end of the shaft, but do not pull the harness out of the column. Turn the lock to Run. If necessary, remove the ignition key. If equipped, remove the buzzer switch assembly. Remove the lock retaining screw and remove the lock cylinder.


How do you remove the ignition module on a 1988 ford f-250?

how do you remove the ignition control module on a 1988 ford f-250 pickup?


How do you install key ingition switch 1988 Chevy S-10?

how do install key ignition switch 1988 Chevy s10


1988 jeep wrangler runs while cranking quits when you let off?

you have an open circut in your ignition switch change your ignition switch.


How do you Remove 1988 Supra Ignition?

I assume this question is about the mechaincal part of the keyswitch. Remove the plastic cover under the steering column and keyswitch. Turn the ignition key to run (not start). Underneath the keyswitch, there is a small round hole. Push something like a paperclip in the hole and the ignition keyswitch will pull right out. If this question is about the electrical switch part of the keyswitch, there is a single Phillips screw holding the switch in place, just remove the screw to remove the keyswitch. www.driftmotion.com