0
I assume this question is about the mechaincal part of the keyswitch. Remove the plastic cover under the steering column and keyswitch. Turn the ignition key to run (not start). Underneath the keyswitch, there is a small round hole. Push something like a paperclip in the hole and the ignition keyswitch will pull right out.
If this question is about the electrical switch part of the keyswitch, there is a single Phillips screw holding the switch in place, just remove the screw to remove the keyswitch.
www.driftmotion.com
What else can I help you with?
How do you remove the ignition module on a 1988 ford f-250?
how do you remove the ignition control module on a 1988 ford f-250 pickup?
What are the symptoms of a bad ECU for a 1988 turbo Supra 7MGTE?
When you turn the ignition on the CHECK ENGINE light will not light up at all.
How do you remove the ignition switch in a 1988 Isuzu pickup?
how to remove lock cyliner switch 1988 Isuzu pickup
When was Montreal Supra created?
Montreal Supra was created in 1988.
How do you change spark plugs on 1987 Toyota Supra 7M-GTE?
if you have ignition coils you have to remove them and the intake tube (3000) then you can take the spark plugs out
How do you remove an ignition lock cylinder from a 1988 Mazda 323?
With an uncle and a hammer.
How do you remove the ignition switch on 1988 ford bronco?
To remove the ignition switch on a 1988 Ford Bronco, first disconnect the battery to prevent any electrical shorts. Next, remove the steering column covers by unscrewing the screws holding them in place. Then, locate the ignition switch, disconnect its wiring harness, and remove the mounting screws that secure it to the column. Finally, carefully pull the ignition switch out of the column.
How do you change or fix an ignition switch on a 1988 Corsica when the key turns but does not actuate anything?
If your 1988 Chevy Corsica key only turns in the ignition and does not start the automobile, it is probably unfixable. Remove the ignition switch retaining ring. Slide the out and remove the wiring harness. Reverse the process to install the new ignition switch.
How do you remove the ignition switch key lock on a 1988 Jeep Cherokee?
Remove steering wheel, turn signal (4 screws), and torx holding ignition, reverse to reinstall.
Where can you get 1988 Supra Electrical Diagrams?
Right here: http://www.cygnusx1.net/supra/library/TSRM/
How do you remove ignition key from 1988 corvette with manual trans?
To remove the ignition key from a 1988 Corvette with a manual transmission, first ensure that the gear shift is in the neutral position. Then, press the brake pedal and turn the ignition key to the off position. Finally, you can pull the key out of the ignition. If the key will not release, double-check that the car is in neutral and the brake is applied.
Where is the 1988 Toyota supra blower fan located?
The blower fan in a 1988 Toyota Supra is located under the dashboard on the passenger side of the vehicle. To access it, you typically need to remove the lower dashboard panel. The blower motor itself is housed within the heater assembly, which is connected to the vehicle's climate control system.
