To remove the ignition key from a 1988 Corvette with a manual transmission, first ensure that the gear shift is in the neutral position. Then, press the brake pedal and turn the ignition key to the off position. Finally, you can pull the key out of the ignition. If the key will not release, double-check that the car is in neutral and the brake is applied.
According to my Alldata system maintenance charts, the 85 Corvette OD manual trans uses Dexron IIE automatic trans fluid. HTH
Automatic or manual trans?
Yes. But It Will Lower The Value Of The Car. These Are A Little On The Hard Side To Find, My Advise Keep It Orginal.
To remove the ignition switch from a 1997 Pontiac Trans Sport, first disconnect the negative battery cable to ensure safety. Next, remove the steering column covers by unscrewing the screws holding them in place. Then, locate and disconnect the wiring harness from the ignition switch, and unscrew the ignition switch from its mounting bracket. Finally, carefully pull the switch out to complete the removal process.
the firing order is 1-8-7-2=6-5-4-3on ls2 manual trans
Yes, however, the trans, and computer will have to come with it....
No dipstick on the manual trans. You have to remove a plug at the midpoint on the side of the case to check fluid.
Just push the button on gear shift and let off gas thanback on -if everything is working you are in overdrive!
10* BTDC for all 1973-1979 manual trans trucks, except California 6* BTDC for all 1973-1979 California trucks, auto or manual trans 6* BTDC for all 1973-1979 auto trans trucks.
Like I said earlier, I put the vehicle on my lift, remove all retaining hardware, and place a trans. jack under the unit and let it down............i have no idea how you will do it.
Driver side rear between firewall and engine block. It is bolted in with one of the engine and trans bolt. You will have to remove the wiper motor to get to it.
== ==