answersLogoWhite

0


Best Answer

this could be you're ABS sensor

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause a hard brake pedal on a 2000 dodge stratus and this car does not have ABS?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Fuses and bulbs fine on your 2002 dodge stratus but still no brake lights advice?

faulty brake light switch (on pedal)


Gear shift lever button will not engage to move the gear shift lever out of park 2006 dodge stratus?

check the brake pedal switch


Where is the brake light switch located in a 2004 stratus?

Under the dash, near the top of the brake pedal arm.


What do you do if the brake lights will not work on your 2000 dodge stratus when all bulbs have been replaced and the fuses are all okay?

Check the stop light switch - usually located at the upper end of the brake pedal under dash area


What brake pedal is the cause of air being in the brake system?

The brake pedal has nothing to do with it. If air is in the system then bleed the brakes.


What fuse controls the brake lighta on a 2000 dodge caravan. all lights work except no brake lights when pedal is pushed?

Check the brake light switch on the brake pedal


Where is brake light switch on 1988 dodge Dakota?

under the dash about 6inches above the brake pedal under the dash about 6 inches above the brake pedal


Where is the brake light switch on a 2003 Dodge ram 2500?

It is on a bracket next to the brake pedal.


Where is the Brake light switch located on 2006 dodge charger?

On the bracket that the brake pedal pivots on.


What would cause the brake pedal to be hard and still no brake lights on a 2006 Lincoln navigator?

brake switch located on the top of the brake pedal


Why 1990 Geo Tracker brake pedal hard to press?

Hardness in the brake pedal can because by low brake fluid. Air in the brake lines can also cause the pedal to push hard.


What could cause the brakes and brake pedal to stick when brake pedal is pressed?

Check around brake pedal for something rubbing. If OK, I'd look into the master cylinder.