0
Stuck valves are usually caused by a build-up of deposits.
Rosalinda Blick
Add your answer:
Earn +20 pts
Which safety valve should be set to discharge at lower pressure drum safety valve or super heater safety vlave?
The Superheater safety valve must be the lowest set safety valve on any boiler, in order that flow through the superheater is maintained.If the drum valve were set lower the flow through the superheater would be disrupted on an overpressure.
What would cause the filler cap dip stick to blow out on a 2003 Harley Sportster?
there is a check valve in the oil system that is stuck open over filling the oil tank will cause the dipstick to blow out of oiltank
How do you repair a clutch valve in an Olds Cutlass and also what would cause RPM's to increase as speed decreases?
Your car if its a stick is not pulling out of gear all the way and your moter overrevs
Would valve cover leak cause the car to stall?
I would not expect a valve cover leak to cause a car to stall. A valve cover leak can fill the spark plug area with oil which can cause rough running.
What would happen if the contianer did not have pressure relese valve?
As the pressure increased, eventually the container would burst. Before such a dangerous pressure is reached, a safety valve would open and automatically release the pressure, preventing the container from bursting. An example is the safety valve fitted to the lid of a domestic pressure cooker used in the kitchen. When the safety valve opened, steam would be released and warn the cook to turn heat on the kitchen stove down to a safer level.
What would cause a 2001 dodge diesel transmission to have governor pressure stick?
Could be a valve problem in trans, or could be a sesnor malfunction in the trans. Have it looked at by a professional, it will save you a headache.
Would a PCV valve cause your truck to lose power?
NO it would not.
What is Difference between relief valve and safety valve?
Relief valve always position in the suction line in oreder to relief the extra pressure, while safety valve is always placed at discharge line to release excess pressure.I would take that one step further by stating that a " RELIEF VALVE" is one that is "meant" to be lifted off its seat, as opposed to a "SAFETY RELIEF VALVE" which is not!DIFFERENCE BETWEEN RELIEF VALVE AND SAFETY VALVE:1. Releif valve is applicable in the fluid system.safety valve is applicable in the gaseous system.2.Relief valve opening is directly proportional to the pressure rise.Safety valve opening is will happen at after reaching the setpressure.3.Mode of relif vlave line is again connected to the suction.But in the safety valve is just vent-out there is no connection tosuction.
Why would a magnet stick to your left chest after a mechanical valve was inserted?
Your mechanical valve is made of surgical steel. Magnets are attracted to steel.
Where is the egr valve on the 91 Pontiac Grand Am?
Would this cause the car not to start If the EGR VALVE is bad
What would cause a visible spark to jump to my valve cover?
wat the #@$!& is a valve cover ...who cares about sparks!!!!
Would a faulty egr valve cause your car to jerk?
A faulty or clogged egr valve can cause an engine to run rough. If stuck or clogged the valve can be cleaned after removal with carburetor cleaner.
