a hole in one of the pistons
Crank My Tractor was created in 1996.
There are several things that can cause diesel fuel to get into your crankcase. A broken piston ring is the most common cause.
best way is take off fuel filter fill with diesel put it back on the pump the primer button a few times then crank tractor
Crank sensor failure. It is located on the front of the engine, points down to the crank pulley.
where is the crank sensor located on a 6.0l ford power stroke diesel
If you're asking about a Kubota utility tractor, the fuel tank is above the filter assembly and the fuel will gravity feed through the filter when the ring nut is loose and of course you open the shutoff valve. Once the filter housing fills up (and you spill a little diesel), close the ring and then crank on the engine until the fuel gets into the pump. It should crank in less than 30 seconds with the fuel control set at half-throttle or higher. This info is based on experience for a Kubota M4700 tractor.
crank sensor
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
because its a ford...
Dont crank it... Drain it out and put gas in it.
There are a few things that could cause this problem. It could be the wiring to the alternator, the alternator solenoid, or the wiring.?æ
i have a 1986 Toyota 4x4 auto 2h diesel with electric and hand crank if battery is flat it has a special radiotr with hole in it for crank handel