answersLogoWhite

0


Best Answer

Crossed wires! or a wire not pushed all the way down, or Possibly but highly unlikely a bad wire

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause rough idle shuddering and loss of power in a 2002 cavalier 2.2 SingleOC after a tune-up with new wires plugs catconverter and coil packs It is not reading ANY engine codes?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would cause no daignostic reading to be available on a 2001 cavalier?

The primary cause for no diagnostic reading to be available on a 2001 Cavalier is a faulty connection or code reader. The computer is designed to automatically transmit codes once an ODBII code reader is connected to the port.


What does check your gauges mean on a 1999 Chevy cavalier?

In my 99 cavalier it means to look at gauges and check to make sure they are reading correctly. Mine goes on when I need fuel. Dummy light is what they are called.


Why does a Vauxhall Cavalier tachometer show the wrong reading and get stuck sometimes?

A tachometer that shows the wrong reading and get stuck sometimes could be caused by faulty wiring between the transmission and tachometer. It could be caused by a defective instrument cluster.


What does check gauges light mean 2003 Chevy cavalier?

It means that the hydraulics which operate your fuel and temperature gauges may be leaking or damaged. One or more of the gauges is out of the normal operating range when engine is running. It could be the oil pressure gauge is reading to low, the temperature gauge is reading to high or the voltmeter is reading to low so, check the gauges.


1994 Chevy Cavalier Z24- The speedometer is reading a faster speed than actually going about 40 mph faster Already changed the speed sensor Any ideas?

speedo cable?


Can you test fuel filter 2000 Chevy cavalier z24?

I dont belive there is a set test for a fuel filter,but, you can put a pressure gauge before the filter,get a reading and then put the guage after the filter and get another reading. But it would be easier to just install a new filter and be done with it. But be careful...gas is dangerous and stinky


Your 2004 Chevy Cavalier temperature gauge is not giving correct reading and The pin is buried all the way around but the engine is not running hot Whats happening?

If you are sure the engine is not running hot then it could be a bad coolant temp sender.


How do you check the 02 sensors on a 2.2 ecotech engine in a 2004 Chevy cavalier?

If you have a bad O2 sensor the check engine light would come on and set a code directing you to which one is bad. A code reading tool would be required to read the codes.


What are 3 types of reading?

Guided reading, shared reading, fluency reading, Independent reading, and reading aloud


How do you fill transmission fluid on 2003 Cavalier?

where yo pull the dip stick marked tansmission, you put a funnel in it and pour until you have a full read on the dip stick, let it be known that people tell people who have a standard tranny that there is no tranny fluid. you should know that a manual trans does not have a filler. If your cavalier is an automatic tranny, you pull the dip stick marked transmission and put a funnel in place of it and pour until dip stck has a full reading.


Have an 02 cavalier it turns over but not getting fuel if you run a jumper to the pump it comes on and the only code it is reading is a p0452 code?

Trouble code P0452 means: Evaporative Emission System Pressure Sensor/Switch Low Input Change out the sensor at that will fix your problem


Where is the Reading in Reading located?

The address of the Reading is: 9001 Reading Rd., Reading, 45215 3101