Replace the flasher.
It makes the signals and the hazards flash.
replace turn signal flasher, hazard flasher is separate
have you tried replacing the flasher u need to replace the flasher can for the turn signals there are 2 one for hazards and one for turn signals usually found in the fuse box, and cost about 3 bucks
Check the fuses and the flasher unit.
Did U checked the turn ligths flasher, switch and wiring?
Bad switch? Bad hazard flasher?
The 1990 VW Jetta turn signals will not work when the ground wire is broken or corroded. The turn signals may need the lightbulb's replaced.
For most vehicles the hazards and signals are two separate circuits, they have separate fuses and separate flashers. Check your signal light fuse and signal light flasher.
Turn signals and hazards are two separate curuits. Check/replace your signal light fuse and flasher.
hazards and turn signals have separate flashers. replace flasher for turn signals
More than likely the flasher relay is defective, replace it.
Maybe a separate flasher for the hazards
you have a bad turn signal flasher.
Check the fuses first of all. I think the Durango has two flashers as well, one for the hazards and one for the signals so it could be a bad flasher.
check you light bulbs
Two separate circuits in most vehicles. You have a fuse and a flasher for the hazards and you have a separate fuse and flasher for the signals.
Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead
On my 2002 Passat the hazards and the turn signals all operate through the same flasher unit that operats the hazards. This is behind the hazard switch. See related questions for removal details.
Defective flasher relay.
I saw in other places that yes it does have separate flashers.
There are two flashers, one for the hazards and one for the signals.
Probably the Electronic Flasher. These ,when the fail,will allow the Signals and/or hazard lights to work intermittently. The flasher is the same for both the signals and hazards.
Could be: Fuse Flasher Switch in column There is another flasher behind the fuse panel that controls the signals