On your brake peddle there is a switch it is either bad or stuck, most likely.
The Chrysler Cirrus did not come out until 1995. You reset the check engine light with a scan tool or by unhooking the battery. If you have not repaired the cause of the code the light will come back on.
The bulb is burnt out or has been removed.
does the third brake light work? if not probably brake light switch but check the fuse first. if yes, there are thes really cheezey circuit boards in the tail light housings that go bad all the time. they look like plastic strips.
Behind fog light on passenger side
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
No, it is a brake light.
If it is like my 2000 Cirrus, I use the key to pop the cover off, then just remove and replace.
With a scan tool.
You can not disconnect the check engine light.
On the bracket the brake pedal mounts to.
On a bracket, above the brake pedal.
check the brake light switch it may have come loose