0
What would cause the fuse for the tail lights and dash to keep blowing in a 1994 Ford Explorer?
Updated: 10/25/2022
Wiki User
∙ 17y agoBest Answer
A short in the wiring.
Wiki User
∙ 17y agoThis answer is:
Add your answer:
Earn +20 ptsQ: What would cause the fuse for the tail lights and dash to keep blowing in a 1994 Ford Explorer?
Write your answer...
Submit
Still have questions?
Related questions
What would cause signal lights to not work on a Ford Explorer?
Most likely turn signal flasher
What would cause the fuse for the interior and tail lights on a 2001 dodge neon to keep blowing out?
A short in the wiring (grounding out)
What would cause the tail lights and fuse to keep blowing out on a 1991 Acura Legend?
Short in the wiring or inside one of the plugs.
What would cause your tail lights and dash light fuse to keep blowing on a 1991 mercury tracer?
you could have a short between the two.
1994 explorer lights dim wipers slow and battery gauge goes to low What would cause this?
Either your battery is dead, or your alternator has failed.
What would cause the interior gauge lights and informantion panel lights as well as the compass lights to go off when the headlights are turned on in a 97 Explorer?
First thing you want to check is the dimmer switch to see if it is turned all the way down.
Why would your breakes keep blowing the fuse?
It's probably your brake lights, not your brakes.
What would cause the tail lights on a 1996 Eddie Bauer Ford Explorer to not come on bc all other rear lights work and I all of the fuses in the car and under the hood are ok?
bulbs or bulb sockets
Would a battery going bad cause a fuse to keep blowing out?
not usually!!if fuse is blowing out check for short!!
What would cause my dashboard lights and tail lights to go out?
a fuse
What would cause the advtrac light too turn on my 2005 Ford Explorer?
what would cause the ADVTRAC OFF light to remain on on my 2005 ford explorer
What would cause the right signal lights to come on when turning on the left in a 2001 ford explorer sport track?
Either the driver is indication the wrong way or the wiring to the indicators is crossed.
Copyright ©2024 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.