The bearing has failed in the water pump. The pump will need replaced.
Failed water pump bearing.
Original pump would have a bolted on pulley.
The bearing in the water pump has failed and the water pump will need replaced.
With a 36mm wrench and a spanner tool to hold the water pump pulley.
How do I replace water pump on 2004 jeep grand Cherokee
It sounds like there is water in the door of your Jeep Grand Cherokee because there may be water in the door of your Jeep Grand Cherokee. You can take your car to a mechanic to be sure, and if necessary, to have the door drained.
The water pump is located on the left side of the car. If you are looking under the hood, it is the upper pulley closest to the grill.
About $70
Look at the radiator fan, behind it you should see a pulley. The pulley is connected to the water pump. The center pulley is attached to the water pump. It is not a hard pump to replace, just a pain in the rear to do so. Y-THINK-Y
The water pump is on the front center of the engine.
yes
The water pump is on the front of the engine. It should be close to the center of the block with a pulley for the drive belt on front of it.