0
When Taking an ohm reading from the compressor terminals to the condensor housing is a way of checking?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How would the compressor housing feel when a unit has an overcharge of refrigerant?
A refrigerant compressor will be hot when running whether or not the charge is too high or too low. If the charge is too low, the compressor will cycle on and off. If too high the compressor may not run at all.
Why is over-pressurizing an Air Conditioning system bad?
Overcharging a refrigeration or air conditioning system can result in an explosion. To avoid serious injury or death, never overcharge the system. Always use proper charging techniques. Limit charge amounts to those specified on the system equipment serial label or in the original equipment manufacturer's service information. Overcharging the system immerses the compressor motor, piston, connecting rods, and cylinders in liquid refrigerant. This creates a hydraulic block preventing the compressor from starting. The hydraulic block is also known as locked rotor. Continued supply of electricity to the system causes heat to build in the compressor. This heat will eventually vaporize the refrigerant and rapidly increase system pressure. If, for any reason, the thermal protector fails to open the electrical circuit, system pressure can rise to high enough levels to cause a compressor housing explosion. Overcharging a refrigeration or air conditioning system can result in an explosion. To avoid serious injury or death, never overcharge the system. Always use proper charging techniques. Limit charge amounts to those specified on the system equipment serial label or in the original equipment manufacturer's service information. Overcharging the system immerses the compressor motor, piston, connecting rods, and cylinders in liquid refrigerant. This creates a hydraulic block preventing the compressor from starting. The hydraulic block is also known as locked rotor. Continued supply of electricity to the system causes heat to build in the compressor. This heat will eventually vaporize the refrigerant and rapidly increase system pressure. If, for any reason, the thermal protector fails to open the electrical circuit, system pressure can rise to high enough levels to cause a compressor housing explosion.
Does housing use steel wire?
Housing uses steel wire
Results from the fact that housing is expensive and time consuming to build?
the supply of housing is inelastic -Apex-
What is detection antenna housing called?
The housing used for a detection antenna is called a radome. This type of housing is made from transparent material, which is often found on the outer surface of an aircraft.
How does power pass through the compressor shell to the motor inside?
Neoprene O rings as the insulator between the terminals and the compressor housing.
What are the parts of turbocharger?
The parts of a turbo going from front to back are: Compressor housing, inside the housing is the compressor and that compresses the air. the compressor housing is attached to the main bearing housing/core, and on the backside is the exhaust turbine inside the exhaust housing.
What are theComponents of turbo c?
Wheel Shaft; Compressor Wheel; Bearing Housing; Turbine Housing; Compressor Housing They are the main parts plus there are internals, Bearings etc.
How do you remove the ac housing in a Honda?
How to remove the ac compressor housing in a honda civic 2001
How many parts are in a turbo?
Generally, you have at least 2 bearings, a compressor wheel, a turbine, a hardened shaft, 2 locks or clips to restrict moment, a compressor housing, a turbine housing, and bolts/nuts.
How do you change the shaft seal on the air conditioner compressor on a Chevrolet Silverado 2000?
Usually the shaft seal is installed from inside the compressor housing and is not serviceable. You would need to replace the compressor.
How would the compressor housing feel when a unit has an overcharge of refrigerant?
A refrigerant compressor will be hot when running whether or not the charge is too high or too low. If the charge is too low, the compressor will cycle on and off. If too high the compressor may not run at all.
Is the thermostat and housing for a 2000 Saturn SL2 1.9l located on the driver's side of the engine or under the compressor?
It's under the compressor off the lower rad hose
Where isAir ride compressor 93 mark viii?
The compressor is located in front of the passenger side front wheel. You have to remove the right front wheel and plastic wheel housing to get to it.
Where is the AC expansion valve located 1993 Honda civic?
The expansion valve is located under the dash. It is within the plasitc housing (box shaped) with the condensor coil. The plastic housing can be removed after taking out the glove box, metal cross bar, and disconnectng the wire harness that runs across the plastic housing.
Where is the thermostat housing on a 1996 Saturn SL2?
Located below the A/C compressor, it has the lower radiator hose attached to it and is held on by (2) 10mm bolts. You can change it with the A/C compressor installed, but will find it easier with the A/C compressor loose and out of the way.
Where can I find affordable housing in London?
You can find affordable housing in London by checking the real estate section of the classified ads of the newspapers in the communities in which you are interested in living.
