Want this question answered?
Potential energy
In parallel connection all the positive terminals are connected with positive of the source and all the negative terminals are connected to negative of the source. Whereas in series connection one positive terminal is connected to the negative of another, like wise it goes on and finally the positive end is connected to the negative of the source.
When the two ends of the conductor are connected to a source of EMF, electricity flows through it.
The energy for the TV comes from the electrical connection it makes to the mains. Some radios (called crystal radios) can operate using only the energy in the broadcast signal, but all TVs must be connected to a power source, usuallly the mains.
That's the whole point of a generator - to convert mechanical energy into electrical energy, by making the generator's parts spin.
To allow the wires to be connected to a source of electricity.
Potential energy
In parallel connection all the positive terminals are connected with positive of the source and all the negative terminals are connected to negative of the source. Whereas in series connection one positive terminal is connected to the negative of another, like wise it goes on and finally the positive end is connected to the negative of the source.
in parallel circuit passive components such as resistor capacitor and inductor are connected in such away tht all components positive sided terminals are connected together and similarly negative sided terminals. and then positive terminal of the source is connected to positive side and vice versa.while in case of series circuit negative terminal of first component is connected to the positive terminal of the second component and so on and then source is connected
a load
Terminal represents or are ends in a Electrical Circuit that connects components in Circuit to the Power Source. Terminals are either Positive or Negative marked at the ends denoting the acceptible floe of electrons across the Circuit.
First, circuits have devices that are run by electrical energy. Second, a circuits has a source of electrical energy. Third, electrical circuits are connected by conducting.
An electrical circuit is a path which electrons from a current source flow. Electric current flows in a closed path called an electric circuit. The point where those electrons enter an electrical circuit is called the "source" of electrons. The point where the electrons leave an electrical circuit is called the "return". The exit point is called the "return" because electrons always end up at the source when they complete the path of an electrical circuit. The part of an electrical circuit that is between the electrons' starting point and the point where they return to the source is called an electrical circuit's "load". ---Nerd
Potential Source connected across a Closed Circuit Path.
You achieve three phase rectification with a three phase rectifier. There is one in the alternator of you car. You have three windings, connected delta, so there are three terminals. Three diodes are connected to these terminals, anodes towards the terminals, cathodes common and connected to the battery. Three more diodes (for a total of six) are connected to the terminals, cathodes towards the terminals, with the anodes common and connected to ground. At any one moment of time, one winding provides voltage to cause two diodes to conduct, charging the battery. As the alternator rotates, the windings and the diodes take turns, effectively providing a three phase AC to DC power source to the battery. If you look closely, there is another set of three, smaller, diodes connected as well, anodes towards the terminals. These diodes provide power for the integrated regulator, but the six main diodes are large and heatsinked into the frame of the alternator.
In a three phase system, connected wye, neutral is the common return, and it is grounded. In a delta connection, there is no neutral.
it is called an electrode