Want this question answered?
why increase the amperage in the electrical circuit of a tractor
If the voltage and amperage are strong enough yes. That's why you can be electrocuted
line neutral amperage
The required amperage for a single family home typically ranges from 100 to 200 amps. This is based on the electrical load and the number of appliances and devices used in the home. It is important to consult a qualified electrician to determine the specific amperage requirements for your home.
The minimum recommended amperage for a house to run a dryer is typically 30 amps. However, it is crucial to consult the manufacturer's specifications and local electrical codes to determine the correct amperage requirement for your specific dryer model and household electrical system.
Depending on the bed you buy, it may require higher voltage or amperage.
why increase the amperage in the electrical circuit of a tractor
The fuses restrict the amperage (electrical current/flow) of the circuit. The fuse is size according to wire size and load requirements. NEVER put in an over-sized fuse as it will allow to much amperage for the circuit which will cause overheating of the circuit and possible fire.
Another homework or exam question? AC electrical power demand is measured in Volt-Amps. Electrical current is measured in Amperes. (Amps or Amperage.) Now you can write about how they can be compared.
If voltage remains constant and resistance is increased, the amperage will decrease per Ohm's Law.
Voltage is a measurement of electrical force and amperage is a measurement of electrical flow. They are two different things altogether.
If the voltage and amperage are strong enough yes. That's why you can be electrocuted
Electrical current stated or displayed as Amperage
Amperage is used to rate cartridge fuses.
Amperage or Amps is a measure of is the flow rate of electrical current that is available.
To answer this question an amperage has to be supplied. Wire size is based on the capacity of amperage it can legally conduct. This regulation is laid out in the electrical code book. To get installations passed by the electrical inspector these rules have to be followed.
A rectifier is a type of welding machine. Fairly new development that changes common electrical supplies to voltage and amperage that can be used to weld. It uses less electricity than standard welding machines (usually transformers). It will require a certain supply (voltage - amperage) that you connect the machine to and should state the minimum requirements somewhere on the machine.