answersLogoWhite

0

Check to see if the switch on top of the steering column is on. Flick the switch in the opposite direction to turn them off. It has a separate switch for it. Hope this helps.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why would this happen... when you step on the brake no brake lights come on. The turn signals come on solid?

sounds like you need new taillight bulbs


I have a 1998 Monte Carlo LS and have problems with the turn signals. I having to hold the lever half way down to signal.The signal nor the brake lights work.What's upas the Fuses are fine?

You have a combination switch that is defective. The turn signal switch cancel one side from blinking so the oyher stays on solid.


1999 ford F150 and the turn signals just stopped working The lights turn on at both the front and back but they just stay solid Also the hazard lights dont work or blink at all?

change the turn signal flasher flasher could be a fuse


What word is used when a solid is turned into a liquid?

Melting is the term used when a solid is turned into a liquid by increasing its temperature.


How does gas turns to solid?

Gas can be turned into solid by sublimation process.


Where is the Mazda B2300 brake light switch located?

All brake light switches are mounted directly behind the brake pedal on a bracket that holds it in place with a electrical push pin that moves in and out when the pedal is depressed.If you have no brake lights but,your tail lights work with your headlight switch on for parking lights the brake light switch needs to be either adjusted and if after this if this does not correct the issue,replace the brake light switch.Most auto zone,advance auto parts,napa will carry this part and very easy to replace.Too easy.Note make sure the bulbs are known to be good in the tail lights by looking at the elements inside and not fried (wire is not solid from left to right side in the bulb) If only one side is not working it would be the bulb,however if both are not the info above answers that.


What is it called when a liquid has turned into a solid?

The process by which a liquid becomes a solid is called "freezing".


What do all of the warning lights on a 2002 Pontiac Montana van mean LCD display in instrument panel cluster?

A circle with the bottom quarter solid with jagged or wavy like lines on the top. The parking brake light comes on as well. I assume I have a brake problem but the book doesn't tell me.This light means low brake fluid level.


What can be turned from liquid to solid?

eggs. water water


What changes from a liquid at a solid?

water can be turned into ice


A oil that has been turned into solid fat?

Petroleum


When a solid is heated up and turned into a liquid what is it?

star