All brake light switches are mounted directly behind the brake pedal on a bracket that holds it in place with a electrical push pin that moves in and out when the pedal is depressed.If you have no brake lights but,your tail lights work with your headlight switch on for parking lights the brake light switch needs to be either adjusted and if after this if this does not correct the issue,replace the brake light switch.Most auto zone,advance auto parts,napa will carry this part and very easy to replace.Too easy.Note make sure the bulbs are known to be good in the tail lights by looking at the elements inside and not fried (wire is not solid from left to right side in the bulb) If only one side is not working it would be the bulb,however if both are not the info above answers that.
I would check the power brake booster
The ABS control module on a 1997 Mazda B2300 is typically located under the hood, mounted on or near the driver's side firewall. It's often positioned close to the brake master cylinder. For precise identification, you may want to consult the vehicle's service manual or a repair guide.
use a c clamp to squeeze the piston closed
How do I adjust a stoplight switch on my mazda 626 LX V6
change stop brake light under foot pedal check fuses first
replace it
The brake switch is located on the brake master cylinder!
there either 10.28x1.33 or 11.20x1.33 You have to take off your wheel and check yourself Mazda Changed there rotors midyear 2002-2003 Kinda Confusing lol.
Above the brake pedal,its black plastic.
under the dash board. it connects close to the brake pedal. blue plastic box. no tools required. flashlight helps alot.
The brake light switch is located on a bracket behind the brake pedal support.
The neutral safety switch, release switch, or brake switch is bad.