Head gaskets can go at any time. Everything will be going just great and then..."POOF" bad head gasket. But you must remember this thing is 19 years old, and after 10 years useally the only thing that works is the check engine light.
Remove the cylinder head from your 1992 Chevy 350 cubic inch engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.
No the head gaskets are dependent on bore size
5.7 chevy silvarodo how to change head gaskets
You probably have a vacuum leak. Check intake manifold and throttle body gaskets as well as vacuum lines.
what is the preceger for replacing the head gaskets on a 1993 chevy suburban 4x4 350
Not on the head gaskets.
The best way is to remove the upper and lower intake. Then loosen all the rocker arms and pull the pushrods ( need to go back in same place during reassembly). remove the head bolts pull the heads off. clean and check, the put it all back together. May have to use new head bolts.
As with all other cars, the head gasket is located between the head and the block.
6hrs
unbolt it
The only repair is to replace the head gasket.
well i just did a head gasket job on my 1992 g30 full size van & it costed me about $185 for all the gaskets , oil & antifreeze