One of the main reasons to use studs 12" on-center would be because of the load they are carrying. If an unusually high load is placed on the wall, that could be a reason. Another could be a high or tall wall that it exposed to wind loads. A wall such as that may need close spacing to comply with building code.
Studs should be spaced 16 inches apart on center. Because of the dimensions of the sheeting, the first stud should be placed 15 1/4 inches from the end. This ensures that the sheeting will land exactly in the center of the fourth stud. Some studs can be spaced 24 inches apart if the wall will not be load bearing. Twelve inch spacings (to centers )is used for additional support around door ways if there is reason to believe that there walk way will be have high traffic, if the wall is an outside facing elevation where whether conditions could impact on the structure and some use 12in centers near windows to provide a more stable structure. - In general building codes for your area and/or country will be required to be followed as codes are not international.
In England typical stud spacing is 16", so 10 studs. Sometimes people use 2' spacing, which would require 7 studs
16 bolt on 6.5 inch spacing is not used on any car. I suspect you mean a 16 inch wheel with 6.5 bolt spacing, unfortunately with out a number of bolts there is no correct answer.
Use 1 stud and a wall anchor on the other end.
I believe the stud spacing is the same. Dont use the Rubicon wheels though cause the rubber is bigger than the standard 1994 height. You would have to have a small lift to get these to fit without rubbing. I have a 1995 Wrangler. Plus the rubicon has a bigger axle and I am not positive if it is the same stud pattern. Good luck.Answerno Answeri would rather suggest not try it coz stud spacing does from model year to model year
Up until 1846 every railway used there own track spacing, many were close to the 8 foot 6 inch size. In 1846 two important railways with 8 foot and a bit spacing decided on the 8 foot 6 and 1/2 inch standard gauge. Since then about 60% of world wide railways use this spacing.
Usually interior walls are usually a 2x4 3 1/2 inches thick with 1/2 drywall on each side so they are 4 1/2 inch thick. Exterior walls are a 2x4 3 1/2 inches thick with 1/2 drywall on the interior and then the exterior covering which can vary in thickness depending on type. In countries that use 'mm' as their measurement, exterior wall 270mm (110mm Brick, 50 Cavity, 110mm Brick/Stud Wood Framing) and interior walls 110mm (Brick/Stud Wood Framing).
you should use a stud
No they are not made the same.
On Microsoft Word, you use a 2.0 line spacing.
No, you don't use drywall anchors if you can use a stud.
The best way is to have a stud finder, once you find the studs anchor your cabinets with woodscrews, make sure your screw is at least 1 inch into the stud, use several screws (the number of screws is dependent on the weight).
For interior walls you want to use 1/2 inch size drywall. You want to use the thicker drywall because its stronger and it's a lot harder to damage than the thinner drywall.