1)to engage or disengage contact between engine and gearbox.
2)to stop vehicle in trafic,signal without trouble.
The same way you use a motorcycle clutch.
You ONLY use the clutch brake when you're at a complete stop.
== At a low RPM it is recommended to use the clutch but at 3rd gear it is alright to shift UP to 4th without pulling the clutch.
Clutch judder is a British term use to describe a clutch shudder. It is caused by the flywheel and the components of the clutch not meeting as they should. It usually means something has gotten on the surface of the clutch.
If you do not use the clutch to shift, there are a couple of parts that will eventually wear to the point of causing the transmission to drop out of gear. Given the cost of clutch replacement or gear replacement, you should always use the clutch. Similarly, you should not downshift (with or without the clutch) to slow the vehicle down. Use the brakes. Brake pad replacement is simple and inexpensive on most motorcycles.)
if you already have a clutch on the 140cc GX just use the chain direct to axel..
The clutch slave cylinder in your 1998 Mitsubishi does not use fluid. The clutch slave cylinder is sealed with grease inside of it.
clutch is used to transfer the power from engine flywheel to gear box
The clutch on a Kawasaki Bayou 300 can be adjusted with the use of the 2 adjusting screws. Turn them clockwise to tighten the clutch and counterclockwise to loosen the clutch.
i have replaced my clutch to 10.5 diemter ,can i re use the morso flywheel/clutch bolts
There are a few different advantages of a centrifugal clutch over a normal clutch. Generally, it is easier to use, and is extremely easy to install for a low price.
Yes