I've always thought it was go (make it) or stop (brake it) meaning you can either succeed and make it or not make it (like the Rangers didn't do against my Cardinals tonight - therefore; brake it or come to a halt.
Go Cards!
March 28
applying pressure to the brake pedal
Usually in every vehicle the brake lights come on when the brake pedal is pushed in. There is a switch connected to the pedal in some way to make the light switch on.
there is no reset on the brake pads, you can check your brake pads sensors they will make the light come on
Check the brake fluid level in the reservoir there is a sensor there that will make the light come on if your level is low.
Depends on the make of car, but most likely you are low on brake fluid. Check it before driving.
Yes , the " BRAKE " light in your dash will come on if the brake fluid is low or your emergency / parking brake is engaged
No. Brake rotors are sold individually specific to your make and model, but it is recommended that you always replace both sides at the same time.
Check brake fluid level in master cylinder Make sure parking brake is released Check to see that parking brake switch has not come loose from its mounting bracket
Check to see if the brake fluid level in your brake master cylinder ( in your engine compartment ) is low , if the brake fluid level is low or your parking brake is on the brake light in your gauge cluster will come on
Could be low brake fluid. Emergency brake could be partly on-make sure it is pulled completely in the up position.
No , the brake light should come on when you press the parking brake pedal , but the ABS light should not come on